Robern FAIRHAVEN Installation Instructions Manual

Text of Robern FAIRHAVEN Installation Instructions Manual

This instruction sheet contains information on how to install Fairhaven full length recess mounted cabinets. When install-

ing cabinets, read “General Notes” and “Determining Cabinet Location” below. Read “Recess Mounting Cabinets” on page 2. If you have pur

Recess Mounting Cabinets

Wiring an Electrical Option 209-1073 FAIRHAVEN Full Length Recess Mounted Cabinet LOCATION OF SCREW HOLES FOR MOUNTING CABINET IMPORTANT! The rough opening must be framed on all four sides and at least 3 3/4” (95.25 mm) deep when fully recessed. NOTE: When using an Electrical option, electric wire must be roughed in prior to installation (see “Wiring an Electrical Option). 1. Place entire assembled unit into rough opening and m

Adjustments, Final Assembly, and Maintenance

Doors The cabinet doors have a three-way adjustment feature. Height, level, and fi t-to-frame can all be adjusted using a #2 Phillips Head screwdriver. HEIGHT: If the door is too high or low, adjust the door down or up with screw #2 as shown in Figure E. This screw is located inside the hinge and requires the door to be opened approximately 90° to access the screw. LEVEL: If the door is out of level or too clo

209-1073 FAIRHAVEN Full Length Recess Mounted Cabinet

Installing Hole Plugs and Screw Head Caps 1. Insert the Shelf Hole Plugs into the unused holes inside the cabinet by pressing them into the holes. 2. Place the white SS241 Screw Head Caps over any exposed screw heads. Cleaning and Care The cabinet door and interior are constructed of mirrored glass and painted aluminum. Use only a damp cloth to clean. Ammonia or vinegar-based cleaners can damage mirror

LARGEUR DU DESSUS

26 1/8" (663,57 mm) 7 1/16" (179,39 mm) LARGEUR DU DESSOUS 23 1/8" (587,37 mm) 5 5/8" (142,87 mm) PROFONDEUR EXPOSÉE 9 5/8" (244,47 mm) PROFONDEUR GLOBALE CÔTÉ EXPOSÉ HAUTEUR 73 3/8" (1863,72 mm) Cette feuille d’instructions contient de l’information sur la façon d’installer l’armoire à montage encastré pleine longueur Fairhaven. Au moment d’installer les armoires, lisez les sections ci-dessous « Remarques générales »

Armoires à montage encastré

Câblage de l’option électrique Armoire à montage encastré pleine longueur Fairhaven 209-1073 6 EMPLACEMENT DES TROUS DE VIS POUR LE MONTAGE DE L'ARMOIRE IMPORTANT! L’ouverture brute doit être encadrée sur les quatre côtés et doit avoir une profondeur d’au moins 3 3/4” (95,25 mm) si encastrée entièrement. REMARQUE : Lorsque vous utilisez une option électrique, un fi l électrique doit être ébauché avant

Ajustements, assemblage fi nal et entretien

Portes Les portes de l’armoire disposent d’une fonction d’ajustement triple. La hauteur, le niveau et l’ajustement du cadrage peuvent tous les trois être ajustés à l’aide du tournevis Phillips #2. HAUTEUR : Si la porte est trop élevée ou trop basse, ajustez-la en la soulevant ou en la rabaissant à l’aide de la vis #2 tel qu’illustré à la Figure E. Cette vis est située à l’intérieur de

Robern Indoor Furnishing Owners Instructions: