TEQ SMART 600 Series Basic Troubleshooting Manual

Text of the manual

Serial # Locations

b. Checking cables & connections c. How to clean camera bezel d. Resetting the board/panel e. Calibrate the board/panel f. Firmware updates g. How to test with your computers h. Creating diagnostic/camera files i. Contacting support

SERIAL NUMBER(#) LOCATIONS

Interactive Flat Panels Serial number will be on the bottom right corner (facing panel) on a white sticker or it can also be found in the “About” section which can be access through the menu button on the left side of the panel. Interactive Whiteboards / Projectors The IWB serial number will be on the lower right hand side of

CHECKING CABLING & CONNECTIONS

Left side of the IFP - check to make sure (1) video cable & (1) USB cable is plugged into the same port HDMI USB Display Port VGA Follow cables to teachers computer make sure they are also plugged in correctly

HOW TO CLEAN THE BOARD/PANEL CAMERA BEZEL

DO Use a microfiber cloth (only) to wipe the bezel & remove dust from around cameras. DO NOT Use any type of liquid or chemicals on the product. Use of air can as it may cause dust to get into the camera. BEZEL CAMERA

RESETTING THE PANEL/BOARD

600/800 series boards • Under the center of the pen tray, locate the ribbon cable, power cable & mini ethernet cable. Unplug all 3 cables, wait 2 minutes then plug the cables back in & let it restart. • When plugging back in watch the pen tray pen slot colors blink which indicates power is turning back on. 600 series boards �

CALIBRATING THE IFP WITH A KAPP MODULE

STEP 1 Tap the source button on the front of the panel A. B. Switch the Source to "OPS HDMI"

CALIBRATING THE IFP WITH A KAPP MODULE

STEP 2 A. B. Click on the Gray bar on the bottom of the panel Tap on the “Settings” icon

Other Whiteboard Manuals