Movacolor MC-TC Manual 

Manual revision : rev.00 Language : ENG Date : February 2021 ...

5 Safety 5 Certification 5 Operating environmental conditions 5 3 MCBalance 6 Introduction 6 3.1.1 MCBalance component overview 6 3.1.2 Weighing frame 7 3.1.3 MCBalance motor 7 Material types 8 Dosing system 9 3.3.1 Mounting the dosing c ...

33 6.2.3 Advanced loader settings 34 6.2.4 MV electrical connection 35 6.2.5 Compressed air requirements 35 6.2.6 Maintenance 35 EX Loader (SFG) 36 6.3.1 Introduction 36 6.3.2 EX hopper loader settings 37 6.3.3 Advanced loader settings 38 6.3.4 EX electric ...

technicians taking care of the metering of dry additives to ensure correct use of the Movacolor dosing unit.  This manual must be read before installing the dosing unit. Keep this manual in a place accessible for all opera ...

Safety The equipment is only designed and may only be used for the dosing of dry additives. Any use that is not in conformity with the instructions is considered improper and as such frees the manufacturer from any liability regarding damage to things and/or persons. Before switching on the unit for the first time, en ...

1. Stepper motor 2. Dosing system (Dosing cylinder) 3. Hopper 4. Curled knob 5. Neckpiece 6. Material discharge slide (in closed position) 7. MC-Balance Load frame 8. OPTIONAL Slide locking bolt (locking the slide-out position) Only supplied together with the optional slide mechanism ...

 Do not touch this weighing frame (and dosing unit) while dosing. This will influence the dosing accuracy.  Do not adjust the safety bolts under the weighing platform. These are for overload protection. 3.1.3 MCBalance motor  The MCBalance dosing units are standard equipped with the stepper motor 2A (LT), in case o ...

micro granules. To determine the kind of material in your application use the description below. The actual capacity of the dosing system depends on: • The volume weight of the material (bulk density); • The specific we ...

The motor shaft is equipped with one flat side which fits exact in shaft of the dosing cylinder. To connect the dosing cylinder just put it on the motor axle while turning it to find the flat side, than press the dosing cylinder completely backwards. 3.3.2 Mounting the dosing auger: To connect ...

The Dosing Cylinder® of Movacolor combined with a stepper motor ensures that the additive output is accurate and regular. The neckpiece (a mixing chamber) is designed to blend the main material and the additive homogeneously. The most common mounting of the neckpiece is between the production machine and the ...