Mopar 77072446AB Instructions

Text of Mopar 77072446AB Instructions

Car FEAD Air Conditioning Add-On Kit

77072446AB 5.7L & 6.4L Crate HEMI K6862610 Call Out Description Part Number Quantity Car AC Add-On Kit 77072446AB 1 COMPRESSOR, Air Conditioning, Fixed Disp. 10S17 68202994AA 1 2 Bolt, M8X1.25X100.00 06509468AA 3 3 Belt W/ AC - 2070mm 05037542AA 1 4 Wiring Harness 05017117AA 1 PLEASE READ ALL INSTRUCTION PRIOR TO INSTALLATION. CALL MOPAR FOR ASSISTANCE OR FOR FRENCH/SPANISH INSTRUCTIONS 1-888-5

DO NOT spin A/C compressor over 8000 RPM, damage may occur.

Wide Open Throttle (WOT) cut-off type A/C compressor controller recommended. Always use the type of PAG oil listed for the model being serviced. Do not mix different types of PAG oils. Refrigerant Oil Level It is important to have the correct amount of refrigerant oil in the A/C system. This ensures proper lubrication of the A/C compress

1. Position the A/C compressor (4) to the engine (5) and install the

3 bolts loosely. Using the sequence shown; upper front bolt (1), then lower front bolt (2), then rear bolt (3), tighten the bolts to the proper torque specification 28 N·m (21 ft. lbs.) NOTE: Typical A/C compressor and refrigerant lines shown. 2. Remove the tape or plugs from the opened fittings on the A/C suction line (3) and the A/C discharge line (4)

9. With the addition of the Car Power Steering Add-On Kit

(77072448), a new 2100 mm belt will be required. Part Number 04627031AA. 10. Connect the engine wire harness to the A/C clutch connector (1). Wiring harness assembly instructions are on page 5. 11. Evacuate and charge the refrigerant system. Starting the vehicle and running the A/C compressor may be necessary for complete system refrigerant charging.

Mopar 77072446AB NOTE: Mating Side View Shown

How to Assembly Wire Harness Insert wire pins through the wire insertion side of the connector until pin locks in place. How to splice and connect blunt ends correctly 1. Place the strands of the wires overlapping each other inside of the splice clip (1). 2. Using Mopar crimping tool (1) or equivalent, crimp the splice clip and wires together. 3. Solder (3) the connection (2) together using ro

Mopar Automobile Accessories Owners Instructions: