S&P CADB-HE BASIC Series Manual 

2. SAFETY REGULATIONS AND “CE” MARKING ...............................................................................................................3 3. GENERAL INSTRUC ...

safety regulations and EU standards. Please read this instruction book carefully, as it contains important information for your safety during the installation, use and maintenance of this product. Keep it at hand for future reference. Pleas ...

The models 45 to 100 are equipped with a bed, due to its weight are supplied without pallets. The unit can be handled by a pallet transporter, a forklift, or a crane. The handling machines will be adapted to the load and the lifting conditions. In all cases, the li ...

These models are designed to be installed hanging from the ceiling or located behind a false ceiling. When installing the unit, is mandatory to distribute the unit weight between all the supports existing in the units: • CADB-HE 04: 4 supports (one in each corner) � ...

with a perimetral bed. This bed must be in contact with the ground or with a fl at surface. It is essential that the weight of the equipment was distributed between all points of support to prevent unit defor- mation. The installer must ma ...

the ground or with a fl at surface. It is essential that the weight of the equipment was distributed between all points of support to prevent unit deformation. The installer must make sure that the ceiling structure and the securing ...

a) Drain pipe b) Female screw c) Joint ring. Install the two drains as indicated in the following drawing: a) Horizontal versions of CADB/T HE 04 to 33 b) Horizontal versions of CADT-HE 45 and 60 c) Vertical versions of CADB/T HE 04 to 33 ...

In these versions, the drainpipe and the siphon are supplied mounted in the unit. 6.1.1. Outdoor installation Whenever possible, it is advisable to be mounted indoors. When it is installed outdoors,it is prefe- rable to place the unit under a cover which offers enough protection to prevent rain falling directly t ...

that the unit support was guaranteed on the 6 existing supporting points being all of them at a same plane. In the case of not supporting the unit on the central supports it is possible that deformation in the structure of the unit could take place, ...