Milwaukee M12 Operator's Manual

WARNING To reduce the risk of injury, user must read and understand operator's manual. ...

hands. • Keep work area clean and well lit. Cluttered or dark areas invite accidents. • • Do not use in the presence of explosive dust, liquids or vapours. • Do not use where oxygen or anesthetics are used. • Do not allow to be used as a toy. Close attention is ne ...

the battery pack or tool outside the temperature Charging range may damage the battery and increase the risk SPECIFIC SAFETY RULES FOR WET/DRY VACUUM repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. SYMBOLOGY Volts Direct Cu ...

Pick-Up/Blower The vacuum can be used for debris pick-up or as a blower, depending on the port used. 1. 2. Installing/Removing the Accessories To install the nozzles, hoses or extensions, push the accessory onto the vacuum inlet. 1 1 2 3 4 5 6 7 7 8 9 10 11 1. Battery compartment latches 2. Midframe 3. Tank 4. Tank l ...

2. Remove the filter. Ensure that the float cage remains in place. Fuel Gauge Starting and Stopping Vacuum To turn the vacuum on low, push the switch to the Speed One (I) position. To turn the vacuum on high, push the switch to the Speed Two (II) position. To turn the vacuum, push the switch to the OFF (O) p ...

NOTE or suction decreases. Repairs For repairs, return the tool, battery pack and charger to the nearest authorised service centre. MAINTENANCE Maintaining Tool WARNING To reduce the risk of injury, always unplug the charger and remove the battery pack from the charger or tool before performing any maintenance. Never disassemble the too ...

SERVICE - AUSTRALIA and NEW ZEALAND 21 Kelletts Road, Rowville, VIC 3178 Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold by authorised dealers in Australia and New Zealand. Milwaukee Electric Tool Corporation 13135 West Lisbon Road, Brookfield, Wisconsin U ...