Milesight UR75 Quick Start Manual

www.milesight-iot.com 2 Welcome Thank you for choosing Milesight UR75 industrial cellular router. This guide describes how to install the UR75 and how to log in the Web GUI to configure the device. Once you complete the installation, refer to the Milesight UR75 User Guide for instructions on how to perform configurations on the device. ...

www.milesight-iot.com 3 1. Packing List Before you begin to install the UR75 router, please check the package contents to verify that you have received the items below. 1 × UR75 1 × Ethernet Cable 1 × Power Adapter 1 × 8-Pin Pluggable Terminal UR75-5G Antennas: 4 × Stubby Cellular Antennas 2 × Stubby Wi-Fi Antennas Antenna Magnet ...

www.milesight-iot.com 4 2. Hardware Introduction 2.1 Overview A. Front Panel of UR75-5G B. Front Panel of UR75-4G C. Left Side Panel 1 LED Indicator Area POWER: Power Indicator SYSTEM: Status Indicator Wi-Fi: Wi-Fi Indicator VPN: VPN Indicator SIM : SIM Status Indicator : Signal Strength Indicator 2 Ethernet Ports & Indicators 3 Cellul ...

www.milesight-iot.com 5 D. Right Side Panel 2.2 Dimensions (mm) 2.3 Connectors Serial Port&I/O Ports Note: For -RS485 model, RXD--->A, TXD--->B. PIN RS232 RS485 DI DO Description 1 --- --- IN --- Digital Input 2 GND --- GND --- Ground 3 --- B --- --- Data - 4 TXD --- --- --- Transmit Data 5 --- --- --- COM Common Ground 6 --- --- --- O ...

www.milesight-iot.com 6 Power Connector 2.4 LED Indicators LED Indication Status Description POWER Power Status Off The power is switched off On The power is switched on SYSTEM System Status Green Light Static: Start-up Blinking slowly: the system is running properly Red Light The system goes wrong VPN VPN Status Off VPN is disconnecte ...

www.milesight-iot.com 7 2.5 Reset Button Reset button is under the SIM slots. Function Description SYSTEM LED Action Reset Blinking Press and hold the reset button for more than 5 seconds. Static Green → Rapidly Blinking Release the button and wait. Off → Blinking The router is now reset to factory defaults. 2.6 Ethernet Port Indic ...

www.milesight-iot.com 8 3. Hardware Installation Environmental Requirements - Power Input: 9-48 VDC (48 VDC is needed for PoE output) - Power Consumption: ≤ 7.9W (In Non-PoE mode) - Operating Temperature: -40°C to 70°C (-40°F -158°F) - Relative Humidity: 0% to 95% (non-condensing) at 25°C/77°F 3.1 SIM Card/Micro SD Card Install ...

www.milesight-iot.com 9 3.4.1 Wall Mounting (Measured in mm) Use 2 pcs of M3 × 6 flat head Phillips screws to fix the wall mounting kit to the router, and then use 2 pcs of M3 drywall screws to mount the router associated with the wall mounting kit on the wall. Recommended torque for mounting is 1.0 N·m, and the maximum allowed is 1. ...

www.milesight-iot.com 10 4. Log in the Web GUI of Router 4.1 PC Configuration Please connect PC to any port among LAN1-LAN4 of UR75 router. PC can obtain an IP address, or you can configure a static IP address manually. The following steps are based on Windows 10 operating system for your reference. (Note: As remote access is disabled ...