Nortroll ComTroll 230 Operation & User’s Manual

It also covers the –T and –S versions. CLOSE OPEN SERVICE RESET TX RX CLOSED OPEN SERVICE NORTROLL AS RTU-30 CRU-200 COMMUNICATION MODULE SLC-200+ POWER MODULE LOCAL REMOTE OFF NORTROLL AS NORTROLL AS REMOTE CLOSE OPEN SERVICE RESET TX RX CLOSED OPEN SERVICE NORTROLL AS RTU-30i LOCAL OFF ...

COMTROLL 230, REMOTE TERMINAL UNIT ........................................................................................... 4 COMMUNICATION................................................. ...

The ComTroll 230 is designed for a complete and modular functionality for monitoring and control of primary and secondary functions in the distribution network. The rack-mounted system can control and monitor a wide range of objects such as pole- mounted sectionalizers, breakers, earthing switches, relay protection, ...

open/close button and the ModeSwitch (Remote/Off/Local) are removed. Each RTU-30 /RTU-30i has dedicated OPEN and CLOSE outputs with accompanying open and closed limit-switch inputs to ensure reliable operation. Details about the RTU-30 /RTU-30i functions and options ...

configurations with up to three RTU cards. (With radio communication only). SLC-200+ is the standard DC/DC regulator where external 12Vdc is available. This is also a battery charger for the backup battery, both when external DC is connected and w ...

Pin 1 is located in the upper left corner of J3. F1: Connects the Low Battery signal from SLC-200+ to Digital Input 1 on the NTM-20/25 Modem. Only used in repeaters. Default set open. F2: Connects either External DC input or the Battery Input to the Analog Input 4 on the first RTU-30 card. Ba ...

12 Vdc GND I2C TP-Net The backplane for additional RTU-30 cards have the same connectors and pin-out as the main backplane. ComTroll 230T Installing the TSU-25 Before powering the TSU-25, connect the antenna to the connector located on the front panel. The GPS antenna needs to be located with a good clear 360 degree view of the sky. ...

thumb, the better the view the antenna has of the sky, the better the signal locks and a good continuous uninterrupted time signal is provided. TSU-25 can only be used together with RTU-30t. When more than one RTU-30t card is installed in the same rack, a Router Mo ...

If the GPS receiver is not able to establish contact with the satellites, the TSU-25 will see that the attempt to download accurate time information failed. When the next sync period expires, the Status-LED will start flashing together with the Sync- LED. The Status-LED will stop flashing when the satellite contact is esta ...