Edelbrock 1403 Installation Instructions

Text of Edelbrock 1403 Installation Instructions

Edelbrock 1403 Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413

Rev. 3/21/13- QT/mc Page 1 ©2013 Edelbrock LLC Brochure #63-0061 EDELBROCK PERFORMER SERIES CARBURETORS Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413 INSTALLATION INSTRUCTIONS ® PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and procedures. However, you should be familiar with an
Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413 Rev. 3/21/13- QT/mc Page 2 ©2013 Edelbrock LLC Brochure #63-0061 POWER BRAKE PORT (Except Marine Models) Rear Lower Side, 1/4 NPT IF NOT IN USE, MUST BE PLUGGED WITH 1/4 NPT PIPE PLUG (SUPPLIED) MARINE FUEL PUMP VENT (Not shown. #1409 & #1410 ONLY) IDLE MIXTURE SCREWS Left screw for left side of carb Right screw for right side of carb FUEL INLET for 3/8” hose (Except marine models #14
Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413 Rev. 3/21/13- QT/mc Page 3 ©2013 Edelbrock LLC Brochure #63-0061 6. Do not use more than 6.5 PSI fuel pressure. Excessive fuel pressure may cause flooding. If your fuel pressure is too high, install an adjustable pressure regulator, such as Edelbrock #8190. 7. It may be necessary to re-route the fuel line to prevent interference with the air cleaner. Test fit your air cleaner on your n
Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413 Rev. 3/21/13- QT/mc Page 4 ©2013 Edelbrock LLC Brochure #63-0061 3. Replace all mounting nuts and washers. EnduraShine™ finish carburetors should use the supplied 5/16” flat washers under any other washers used. Hand tighten with a short box-end wrench, alternating between diagonally opposed nuts. CAUTION: Overtightening may break carb base and void your warranty. 4. Connect all th

Edelbrock Automobile Parts Owners Instructions: