Konig KN-STUDIO20 Manual 

Photo studio ANLEITUNG (S. 3) Fotostudio MODE D’EMPLOI (p. 4) Studio de photo GEBRUIKSAANWIJZING (p. 6) Fotostudio MANUALE (p. 7) Mini studio fotografico MANUAL DE USO (p. 8) Estudio fotográfico HASZNÁLATI ÚTMUTATÓ (o. 10.) Fotóstúdió KÄYTTÖOHJE (s. 11) Ministudio BRUKSANVISNING (s. 12) Fotostudio NÁVOD K POUŽITÍ (s. 14) Foto studio MANUAL DE UTILIZARE (p. 15) Studio foto ΕΓΧΕΙΡΙΔΙΟ XPHΣHΣ (σελ. 16) Photo studio BRUGERVEJLEDNING (s. 18) Fotostudie VEILEDNING (s. 19) Fotostudio

5400 K Ra: >90 Voltage: 230 V Lamps: Two pieces Wattage of lamps: 2 x 24 W = 48 W Reference exposure value: ISO200 f/8 1/60 (white background) Width of object to be shot: Approx. 30 cm Size of open position: Approx. 47 x 47 x 47 cm Size of closed position: Approx. 47 x 47 x 9 cm Photo 1 Photo 2 Method of Operation: 1. Open the four reflecting boards, and then open the background board from under the reflecting board. See Photo 1. 2. Attach the background to the background board and bottom reflecting board using the small clamp. 3. Close the top reflecting board onto the background board using the small clamp. See Photo 2. 4. Put the object to be shot onto the background, switch on the 230 V power, turn on the lamps for 3 to 5 minutes, then you can start taking the pictures. 5. Set the white balance of DC to “A” or “ ” or “K” or “PRE ”. To take photos with white colour background, please use the ISO200 f/8 1/60 exposure value for test shooting, to choose other colour backgrounds, please increase the exposure value. 6. While shooting, if the effect of a top light to dim the project is needed, please raise the top reflecting board slightly upwards; If the effect of left light to dim the project is needed, please open the left reflecting board slightly. If the effect of right light to dim the project is needed, please open the right reflecting board slightly. 7. When shooting is finished, please turn off the power. To store, please remove the background, close the background board, then close the bottom and top reflecting boards, and finally close the left and right reflecting boards. 8. To change lamps, please turn off the power, remove the transparent protective cover by loosening the bolts, pull out the broken lamp and insert a new lamp, then put the protective cover back. Safety precautions: To reduce risk of electric shock, this product should ONLY be opened by an authorized technician when service is required. Disconnect the product from mains and other equipment if a problem should occur. Do not expose the product to water or moisture.

Warranty: No guarantee or liability can be accepted for any changes and modifications of the product or damage caused due to incorrect use of this product. General: Designs and specifications are subject to change without notice. All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognized as such. Keep this manual and packaging for future reference. Attention: This product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collections system for these products. DEUTSCH Fotostudio GEBRAUCHSANWEISUNG Technische Informationen: Farbtemperatur: 5400 Kelvin Ra: >90 Spannung: 230 V Lampen: zwei Stück Elektrische Leistung d. Lampen: 2 x 24 W = 48 W Belichtungswert: ISO200 f/8 1/60 (weißer Hintergrund) Breite des Zielobjekts: ca. 30cm Größe geöffnet: ca. 47cm x 47cm x 47cm Größe geschlossen: ca. 47cm x 47cm x 9cm Foto 1 Foto 2 Betriebsweise: 1. Klappen Sie die vier reflektierenden Platten auf und holen Sie anschließend die Hintergrundplatte unter den reflektierenden Platten hervor. Siehe Foto 1. 2. Befestigen Sie den Hintergrund mit der Halterung an der Hintergrundplatte und der reflektierenden Bodenplatte.