Knoll k. base Installation Instructions Manual

Text of Knoll k. base Installation Instructions Manual

© Knoll, Inc.

1 of 9 IMPORTANT SAFETY INSTRUCTIONS When using an electrical furnishing, basic precautions should always be followed, including the following: Read all instructions before using this product. DANGER – To reduce the risk of electric shock: 1. Always unplug this furnishing from the electrical outlet before cleaning. WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons: 1. Unplug from outlet before putting on

© Knoll, Inc.

2 of 9 Step 1. Adjust the width of the frame assembly. D — Foot x2 A — Frame End x2 I —Machine Screw x8 M— Worksurface F — Programmable Digita Handset J— Countersunk Screw x8 B — Crossbar (Pre-Installed) C — Lifting Column x2 G — Leg Cable L —Set Screws (Pre-In- stalled) x4 O — Hex Wrench H — Power Cable K — Wood Screw x14 A — Frame End x2 B — Crossbar (Pre-Installed) 1 2 3 4 M Hardware

© Knoll, Inc.

3 of 9 Step 2. Attach legs to the frame. C — Lifting Column x2 ! Tighten screws in an “X-Direction.” 1 4 3 2 J— Countersunk Screw x8 P — Hex Wrench

© Knoll, Inc.

4 of 9 Step 3. Attach base to the worksurface. L —Set Screws (Pre-Installed) x4 K — Wood Screw x8 O — Hex Wrench M— Worksurface CAUTION NO IMPACT DRIVERS OR OTHER HIGH TORQUE EQUIPMENT ARE TO BE USED. ! Note Side Bracket Alignment: 24" D Base - 1¼" from back edge 30"D Base - 15/8" from the back edge Note: Max allowable overhang is 15" Washer goes here between head and worksurfaces

© Knoll, Inc.

5 of 9 Step 4. Attach feet. D — Feet x2 I —Machine Screw x8 P — Hex Wrench ! Tighten screws in an “X-Direction.” 1 4 3 2

© Knoll, Inc.

6 of 9 Step 5. Install the handset. F — Programmable Digital Handset 1 2 3 4 M Left Side Right Side Digital Handset (“F”) can be mounted on the Left or Right Side. K — Wood Screw x2

Knoll Indoor Furnishing Owners Instructions: