Huawei FusionModule500 Manual 

Quick Guide (02116410, 02116411, 02116412) Huawei Technologies Co., Ltd. Issue: 01 Date: 2021-07-15 ...

All rights reserved. Item Specifications Cabinet dimensions (H x W x D) Converged Cabinet: 2000 mm x 600 mm x 1100 mm Installation scenario Single-cabinet scenario Installation space The cabinet provides 42 U available space. The mounting bars are adjustable forward or backward, and space is reserved at the ...

components may vary.  If the IVS, server, and LAN switch are configured, determine their installation positions based on the site requirements. No. Component Onsite Installation (1) ECC800 Not required (2) Power distribution subrack Not required (3) UPS Not required ...

engineering layout diagram. 2. Place the cabinet at the correct installation position. 3. Level the cabinet using a wrench.  Use a measuring tape to check that the vertical distance between the top of the 2000 mm high cabinet and the floor is 2000 mm (+3 mm). Then use a level to check ...

lithium battery at the 2 U or higher position in the cabinet.  For the 02116411 cabinet, install the lithium battery at the 11 U or higher position in the cabinet.  For the 02116412 cabinet, install the lithium battery at the 14 U or higher position in the cabinet.  One lithium battery occupies 3 U space. ...

of the cabinet.  For the 02116411 cabinet, two horizontal PDU2000s are installed. Intelligent PDU2000s and non-intelligent PDU2000s are supported. Non-intelligent PDU2000s are installed at the 11 U and 13 U positions at the rear of the cabinet. Intelligen ...

1. (Optional) Remove the baffle plate from the front door of the Converged Cabinet. 2. (Optional) Install the PAD support fastener on the back of the front door of the Converged Cabinet. 3. Adjust the PAD mounting support to match the dimensions of the PAD to be installed. 4. Remove the nuts from the PAD mounting support and install th ...

 The installation positions of the T/H sensors can be adjusted as required.  The default device address is 1. Installing Remote T/H Sensors for the Smart Cooling Product Installing T/H Sensors for the Cabinet 12 1. Place the water sensor on the floor under the cabinet. 2. Use an electrician's knife to cut a cross in the rub ...

installed. If not, install them first. 4.5 (Optional) Installing a Server 2. Install guide rails. 3. Place the server on the guide rails and push it in to the cabinet. 4. Secure the server. It is recommended that the server be installed at the 33–34 U position of t ...

2. Secure the camera to the mounting plate. (1) Cable outlet 4.6 (Optional) Installing a Camera 3. Secure the mounting plate to the top of the cabinet front door. 4. Adjust the camera. 5. Install the transparent cover. ...