Eden WT800 Operation Manual

Text of the manual

Bass Guitar Amplifier

Covering Model WT800 (B Version) THE LEADER IN BASS AMPLIFICATION. ©07-15-2005 by U.S. Music Corp.

Bass Guitar Amplifier

WT800B OPERATION MANUAL Publishing Date 07-15-2005 FOREWORD Congratulations on the purchase of your new Eden World Tour Integrated Amplifier System. All of us at Eden are totally committed to providing you with the very best bass guitar systems in their class. Our goals are to offer you the outstanding performance quality of a top-not

The Eden line of World Tour amplifiers is the result of our research and

development in combining high performance and compact size. Just as a skilled craftsman needs good quality tools that won't let him down on the job, so does a good musician. We hope you enjoy the tool we’ve created for you. Have fun; play low! Please read this manual in its entirety

Your ears are your most important piece of

equipment. Unfortunately, they cannot be replaced as easily as your other gear. Please take the following warning seriously. This product, when used in combination with loudspeakers and/or additional amplification may be capable of producing sound levels that could cause permanent hearing loss. DO NOT

FRONT PANEL FEATURES

Input Jack – Designed to accept a standard _ inch mono phone plug. For best results use a high quality shielded cable to connect your instrument to the amplifier. The input is buffered and will handle standard passive, high level active, and piezo input signals. Gain Control – Regulates the first gain stage of the preamplifier and

EQ Clip Light – indicates clipping in the EQ section. Clipping is a Very

Bad Thing and should be avoided at all times. We’ll tell you how to avoid this later in the manual. Compressor Defeat Switch – To defeat the Auto-Compression circuit, depress this switch. Compressor Indicator Light – Indicates compression is taking place. Master Level Control

Output Limit Indicators – Light to indicate activity of the power amplifier

limiting circuit, which protects the speaker system from severe distortion. These LEDs indicate that the amplifiers have reached their maximum output level. DC Indicator – When lit, shows that the low voltage power supplies are operating. Mains On/Off Switch – This switch tur

Bridge Mono Output – This is a single NL-4 connector to be used ONLY

in Bridge Mono operation. . The total speaker load impedance should not go below 4 ohms. Combination Power Cord Jack and Fuse Holder – The removable power cord is attached here. To access the fuse holder, pull the holder out of the top of the power receptacle. Your unit was shipped wi

D.I. Level – Controls the level being sent from the XLR balanced output

jack. We suggest setting the control at approximately 12 o’clock initially. If the signal to the board is too hot, it’s better to engage the Input Pad on your channel of the board than to turn it down here, if at all possible. In general, it’s better (in terms of signal-to-nois

Other Amplifier Manuals