Wasp 2D Reference Manual

tion or the procedures described therein may be reproduced or transmitted in any form or by any means without prior written permission of WASP Technologies or its wholly owned subsidiaries. Owners of WASP products are hereby granted a non- exclusive, revocable license pursu ...

1 Table of Contents Chapter 1 Getting Started.........................................................1-1 About This Manual ............................................................................ 1-1 Manual Conventions .................................................................... 1-2 Resetting the Standard Product Defaults ...

User-Specified Good Read Delay .........................................................3-4 Trigger Modes ...................................................................................3-4 Manual/Serial Trigger ..................................................................3-4 Scan Stand Mode .................................. ...

3 Data Format Editor ..................................................................... 5-5 Data Formatter .......................................................................... 5-5 Alternate Data Formats ............................................................... 5-6 Chapter 6 Symbologies .................................. ...

Power Image Configurator Operations ..........................................10-3 Temporary Configuration Using Configurator .................................10-4 Installing Power Image Configurator from the Web ........................10-4 Chapter 11 Serial Programming Commands ........................... 11-1 Conventions ......... ...

1-1 Chapter 1 Getting Started The DuraLine™ 2D Imager marks a new performance level for hand- held area imagers. They deliver aggressive read rates and depths of field on 1D, stacked linear, and matrix codes. This aggressiveness applies even in challenging reading environments where low lighting conditions and poor quality might m ...

Manual Conventions The symbols listed below are used in this manual to notify the reader of key issues or procedures that must be observed when using the PDA: Resetting the Standard Product Defaults If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the facto ...

Product Reference Guide 1-3 Plug and Play Plug and Play bar codes provide instant Imager set up for commonly used interfaces. Connecting the Imager with an RS- 232 Serial Port 1. Turn off power to the terminal/computer. 2. Connect the appropriate interface cable to the imager. NOTE After you scan one of the codes, power cycle the host terminal ...

3. Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the connector to the port. 4. If the terminal does not support Power Off the Terminal (P.O.T.) connections plug the power supply into the host connector and the AC outlet. 5. Once the imager has been fully connected, ...