Juniper NetScreen-5GT Wireless Getting Started Manual

CONNECTING THE DEVICE Using the instructions below, connect the NetScreen-5GT Wireless device and prepare to configure the device to protect your network. Use the LEDs on the front panel of the device to help you determine the device status. Step 1 Connect an Ethernet cable from the Untrusted port of the NetScreen-5GT Wireless device to ...

CONFIGURING THE DEVICE Use the Initial Configuration Wizard (ICW) to configure the NetScreen-5GT Wireless device. Before starting the ICW, decide how you want to deploy your device. (For additional information, see the NetScreen-5GT Wireless User’s Guide.) Network Address Translation (NAT). You can deploy the NetScreen device in Route ...

Step 5 Port modes bind physical ports, logical interfaces, and zones. • Trust-Untrust mode, the default, binds the Trusted interface to the Trust zone. • Home-Work mode binds interfaces to the Untrust, Home and Work zones. • Dual-Untrust mode binds interfaces to the Trusted and wireless2 interfaces in the Trust Zone. If you want t ...

BASIC SECURITY AND POLICY ADMINISTRATION You must register your product at www.juniper.net/support/ to activate certain ScreenOS services, such as the Deep Inspection Signature Service. After registering, use the WebUI or CLI to obtain the subscription for the service. Step 1 Using Policy Wizards. By default, the NetScreen device permit ...