Johnson Controls Tyco HSM2HOST Installation Manual

ationonthe limitationsastoliabilityof the manufacturer.The entire manualshouldbe carefullyread. HSM2HOST 2-Way Wireless Transceiver ...

Specificationsandfeatures 3 CompatibleDevices 3 Safetyinstructions 5 Introduction 6 Controls and indicators 6 InstallingtheHSM2HOST 7 Temporary mounting requirements 7 Connecting the HSM2HOST to the alarm panel 7 Enrolling The HSM2HOST 8 Enrollingwirelessdevices 8 Testing the wireless device placement 8 Permanently mounting the HSM2HOST and ...

l Current Draw: 60mA l Voltage: Draws current from the PowerSeries Neo or PowerSeries Pro alarm controller (10.8VDC to 12.5VDC) - (Limited Power Supply) l Frequency: 433MHz (HSM2HOST4), 868MHz (HSM2HOST8), 912-919MHz (HSM2HOST9UL) l Zones - can receive signals from up to 128 wireless zones, plus 16 wireless keypads. Also supports ...

Compatible devices PowerG wireless curtain PIR motion detector PGx924UL PowerG wireless PIR motion detector with camera PGx934(P)UL PowerG wireless outdorr PIR motion detector with camera and with anti-masking PGx944(P)UL PowerG wireless mirror optic PIR motion detector PGx974(P)UL PowerG wireless dual technology (PIR and MW) with anti- masking PGx984( ...

Read the safety information before you install the equipment. IMPORTANT- This equipment must be installed by a skilled person only. A skilled person is an installer with appropriate technical training. The installer must be aware of potential hazards during installation and measures available to minimize risks to the installer and ...

Rapid flashing = update failed TroubleCondition: l No trouble: 1 rapid flash every 10 seconds. Iftroublesarepresent,aseriesofflashesoccurevery2seconds. Eachseriesofflashesindicatetroublesasfollows: l 1 flash: Module not enrolled l 2 ...

This section describes how to install the HSM2HOST module. Temporary mounting requirements Before installing the HSM2HOST, you must temporarily mount the HSM2HOST in a location that meets the following requirements. l Ensure that the location is dry. l Ensure that the location is within the operating temperature range. l Ensure that t ...

The enrollment of a HSM2HOST to an alarm panel is dependent on the system configuration. Enrolling the HSM2HOST without a hardwired keypad To enroll the HSM2HOST without a hardwired keypad, complete the following steps: 1. Turn on the wireless keypad by connecting the power source. 2. Simultaneously press [*] and [1] on the keypad. Not ...

Once you identify a suitable location to permanently mount the HSM2HOST and wireless devices, complete the following steps: 1. Pull the Corbus wires through the holes at the back of the HSM2HOST cabinet. 2. Using a screwdriver, securely mount the HSM2HOST cabinet of to the wall using the three screw supp ...

[804][001]-[716] Wireless Device Configuration To configure wireless devices, complete the following steps: 1. Enter Installer Programming section [804] then select one of the following sub-sections: l 001-248 – Configure Wireless Zones l 601-632 – Configure Wireless Keys l 701-716 – Configure Wireless Keypads 2. S ...