Labnet Enduro E0203 Instruction Manual

Instruction Manual This manual is available in additional languages at www.labnetlink.com. Catalog Numbers: High Amperage (250V) E0203 E0203-230V General Purpose (300V) E0303 E0303-230V ...

1.0 Warning: Federal Communications Commission Advisory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2.0 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2.1 Avoiding Electrical ...

1.0 Warning: Federal Communications Commission Advisory This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a comme ...

3.1 Upon Receiving the Instrument Examine the unit carefully for any damage incurred during transit. Any damage claims must be filed with the carrier, keep the supplied box for inspection. The warranty does not cover in-transit damage. To ensure safe, reliable operation, always operate the Labnet Enduro™ Pow ...

5.0 Overview and Operational Modes The Labnet Enduro™ Power Supplies are microprocessor-controlled power supplies that are designed to meet most electrophoresis needs in a single, easy to use unit. The power supply’s small footprint and stacking feature conserve valuable bench and wall mounted shelf space. The powe ...

Control Buttons � Up Arrow: Used to move cursor up between parameters and to increase numeric values. � Down Arrow: Used to move cursor down between parameters and to decrease numeric values. � Mode: Used to choose either Constant Voltage, Constant Current, or Constant Power mode, and sets timer setti ...

9.0 Operating Instructions 9.1 Constant Operation Protocol The Constant Voltage, Current (250V and 300V), or Power Mode (250V Only) allow you to specify a voltage limit, current limit, and power limit to be used during the entire duration of electrophoresis. Review the guidelines provided in this manual before starting ...

7. Press Start/Pause again to pause power supply, and the “run” LED will flash. To change the run settings, press MODE (see Step 3). 400mA TIME:00:00 VOLT:300V PAUSE 8. When the run is completed the power supply will beep and the screen displays TIME UP. 400mA TIME:00:00 VOLT:300V TIME UP 9. Press Stop to ...

Viewing a Program 1. Select the file number using the ▼▲ arrow keys when highlighted press the Mode key. 2. Press the Mode key 3 more times to advance to the programming. 3. If multiple steps use the Mode key to advance through the program to the next step. Editing a program 1. When a file is selected the parameters ...

11.0 Troubleshooting Review the information in the table below to troubleshoot operating problems. Problem Possible Cause Solution LCD screen remains blank, and the fan does not run when the power is turned on AC power cord is not connected. Check AC power cord connections at both ends. Use the correct cords. ...