pro.point 9027525 Manual 

 ...

V1.0 2 For technical questions call 1-800-665-8685 Horsepower 2 HP Voltage rating 110V AC Amperage rating 14A Phase 1 Frequency rating 60 Hz Number of speeds Variable Speed rating Low: 100 to 265 RPM High: 200 to 500 RPM Chuck size 3/4 in. Spindle travel 4-11/16 in. Spindle taper MT2 Max. spindle to base 4-9/64 in. ...

9027525 Visit www.princessauto.com for more information 3 WARNING! This notice indicates a specific hazard or unsafe practice that could result in severe personal injury or death if the proper precautions are not taken. CAUTION! This notice indicates a potentially hazardous situation that may result in minor or modera ...

V1.0 4 For technical questions call 1-800-665-8685 3.2 Do not use tool in damp or wet locations. 3.3 Keep work area well lit (500 Lux recommended). 3.4 Do not use tool in the presence of flammable liquids or gases. 3.5 Ensure there is adequate space to gain access to the tool’s plug, mains, and motor on/off sw ...

9027525 Visit www.princessauto.com for more information 5 11. When using the drill, always ensure a safe operating distance from any swarf and do not reach into the cutting area, or near the cutter, when the machine is running. 12. Connect dust extraction and collecting equipment, if devices are provided, ensuring the ...

V1.0 6 For technical questions call 1-800-665-8685 22. Watch what you are doing, use common sense and do not operate the tool when you are tired. Do not operate the machine when under the influence of alcohol or any illegal substances. 23. Check for damaged or missing parts before using the tool; it should be caref ...

9027525 Visit www.princessauto.com for more information 7 Read before using the machine.  When using electrical tools, basic safety precautions should always be followed to reduce the risk of electric shock, fire and personal injury.  Ensure the magnet is off before plugging in the machine.  Do not use in wet ...

V1.0 8 For technical questions call 1-800-665-8685  Always remove tie, rings, watches and any loose adornments that might entangle with the rotating machinery before operating.  Always ensure that long hair is securely enclosed by an approved restraint before operating the machine.  Should the cutter becom ...

9027525 Visit www.princessauto.com for more information 9 WARNING! Always disconnect the machine from the power source before changing cutters. WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to do so could result in a malfunction and personal injury. Remove ...

V1.0 10 For technical questions call 1-800-665-8685 2.1. If operating in an inverted position, the gravity-fed coolant will not work. Cutting paste or another form of lubricant should be used. 3. Depress the pilot to ensure cutting fluid is being properly metered. 4. Clear any debris or clutter near or in the tool ...