VTech IS7121 Installation Manual

with wireless doorbell Before using this product, read this Installation guide for instructions for installing the telephone base, handset and doorbell. For basic settings and operation instructions, see the provided Abridged user’s manual. Basic steps to install yo ...

Battery Pack BT164392/BT264392 2.4V 550mAh Ni-MH WARNING : DO NOT BURN OR PUNCTURE BATTERIES Made in China CR1222 2 Install handset battery 1 2 3 4 Charge for at least 30 minutes before initial settings. Charge for 13 hours before initial use. Light on! Battery Pack / Bloc-piles : (2.4V Ni-MH) WARNING / A ...

(optional) 4 3 2 1 Unplug! Unplug! Plug! Click! Slide the bracket down! ...

BASIC INSTALLATION COMPLETED! Keep reading for doorbell location testing. ...

Before mounting the doorbell on a wall, make sure you test if the location you install the doorbell is in range, and adjust the camera angle to best suit your needs. To test the location for installation: Hold the doorbell in the location where you want to install the doorbell, then follow the steps below to test the reception r ...

Keep reading for doorbell wall mount installation. To adjust the shooting area, you may either relocate the doorbell in different height level, or adjust the camera angle (see the section below). To adjust the camera angle: Tilt the lever to adjust the angle of the camera lens. The camera lens can be adjusted to left, r ...

Make sure you have done Step 5 above before you mount the doorbell on the wall. If you drill the holes into a stud, go to Step 3. -OR- If you drill the holes into the wall, insert the wall anchors into the holes. 2. Use the two holes on the doorbell wall mount to mark the desirable installation location on the wall. 1. ...

doorbell wall mount, then route the power adapter cord through the hole. 4. Align the wall mount and screws with the holes in the wall (or stud). 3. Align Open a hole Route through the hole ...

of the wires underneath the metallic plate as shown. Twist the screws to secure. 5. If you already have a wired doorbell installed, see Installing the doorbell with an existing wired doorbell on pages 12 to 14 to i ...

sealed tightly. This doorbell meets the IPX4 waterproof standard. Make sure the doorbell is tightly sealed with its wall mount in order to maintain its waterproof ability. 6. Tighten the screw Tighten the screw into the threaded socket at the bottom to secure. 7. Push Push Seal tightly ...