Whispbar K823W Fitting Instructions Manual

Text of Whispbar K823W Fitting Instructions Manual

Fitting Instructions for Basic Carrier

D Montageanleitung für Basisträgersystem ES Instrucciones de montaje para el sistema de transporte F Instructions de montage pour Basic Carrier NO Monteringsanvisning for takstativ PT Instruções de Montagem para sistema de transporte. RU Установочные Инструкции для Поперечных Балок x 1 x 1 x 1 x 1 x 2 x 2 x 2 x 2 Revision No: 4D 1

MAX kgs (lbs)

W/P WHD Audi A6 , 4dr Sedan 12-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs) A6 , 4dr Sedan 12-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs) A6 , 4dr Sedan 12-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs) A6 , 4dr Sedan 12-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs) A6 , 4dr Sedan 12-+ US 75 kgs (165 lbs) 75 kgs (165 lbs) 2

First Time Installation

G Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. G This kit fits type A, B, C and D. G These instructions show type A crossbar fitted. They also apply to type B, C and D. NOTE: Clamp images in these instructions may not be representative of the clamps in this kit 3

G Use keys to remove covers.

G Use hex screwdriver to reverse adjusting screw 10 turns. G Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment method. G Ensure each end of the crossbar is adjusted equally. 4

G Remove locking screw.

G Apply protective strip as shown. Trim if required. G A = Grey G It is important to put the clamps in the correct position on the vehicle. G Letters refer to the part numbers stamped on clamps. G Clamp Part Number: A = A369 B = A370 C = A371 D = A372 5

G Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on the vehicle (For example; "Front Right"). G Refit locking screw so that it goes through the hole in the clamp. Do not begin to tighten the locking screw. G Refer to the underside of the pad for the part number. 6

G It is important to put the pads in the correct

position on the vehicle. G Letters refer to the pad part numbers and position. G Pad Part Number: A = 295A B = 296A G Fit rubber pads (supplied with fitting kit) to foot. Pad may vary in shape to that shown. G Make sure the pad fits into the holes underneath the foot. 7

G Place crossbar on vehicle. Minimum

recommended spacing between the bars is 700mm (27 1/2") (unless otherwise stated). G Please check the rear of this manual for information relating specifically to your vehicle. G Adjust the legs on the crossbar so that they are positioned equally from the ends of the crossbar, and the clamps engage firmly on the body work of the vehicle. G Tighten adjusting screw to 5 Nm (3.7 ft lb) hand tig

Whispbar Automobile Accessories Owners Instructions: