Whispbar K807W Fitting Instructions Manual

Text of Whispbar K807W Fitting Instructions Manual

Fitting Instructions for Basic Carrier

x 4 x 4 x 4 x 4 x 1 x 1 x 1 x 1 x 1 x 2 x 2 Revision No: 2B 1

MAX kgs (lbs)

W/P WHD Citroen C3, 5dr Hatch 09-+ EU 70 kgs (154 lbs) 70 kgs (154 lbs) C3, 5dr Hatch 10-+ NZ 70 kgs (154 lbs) 70 kgs (154 lbs) C3, 5dr Hatch 10-+ AU 70 kgs (154 lbs) 70 kgs (154 lbs) C3, 5dr Hatch 10-+ ZA 70 kgs (154 lbs) 70 kgs (154 lbs) 2

Whispbar K807W C3, 5dr Hatch 09-+ (EU)

-305mm 370mm - 790mm 705mm - -12" 14 9/16ths" - 31 1/8ths" 27 3/4ths" - C3, 5dr Hatch 10-+ (NZ) -305mm 370mm - 790mm 705mm - -12" 14 9/16ths" - 31 1/8ths" 27 3/4ths" - C3, 5dr Hatch 10-+ (AU) -305mm 370mm - 790mm 705mm - -12" 14 9/16ths" - 31 1/8ths" 27 3/4ths" - C3, 5dr Hatch 10-+ (ZA) -305mm 370mm - 790mm 705mm - -12" 14 9/16ths" - 31 1/8ths" 27 3/4ths" - 3

G Only suitable for models with Trap Door

option on roof strip First Time Installation G Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. G This kit fits type A, B, C and D. G These instructions show type A crossbar fitted. They also apply to type B, C and D. 4

Whispbar K807W G Use keys to remove covers.

G Use hex screwdriver to reverse adjusting screw 10 turns. G Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment method. G Ensure each end of the crossbar is adjusted equally. 5

G Adjust crossbar in or out to suit vehicle.

Refer to the crossbar instructions for crossbar adjustment. G Attaches to factory-fitted mounting points G Please check the front of this manual for information relating specifically to your vehicle. G Tighten adjusting screw to 5 Nm (3.7 ft lb) hand tight. G Remove plastic clamp block by gripping bar leg with fingers and push firmly with thumbs until clamp block drops out behind leg. 6

G Select plastic internal block (from fitting kit)

and insert into foot. G Repeat for all legs. G Refer to the underside of the pad for the part number. G It is important to put the pads in the correct position on the vehicle. G Letters refer to the pad part numbers and position. G Pad Part Number: A = 11-04-229 B = 11-04-230 C = 11-04-233 D = 11-04-234 7

G Fit rubber pads (supplied with fitting kit) to

foot. Pad may vary in shape to that shown. G Make sure the pad fits into the holes underneath the foot. Fitment G Open or remove fixed-point covers. G Place mounting block into position as shown. G Right = A539 Left = A393 8

G Slide mounting block to front, so the thread

is above mounting point. G Insert grubscrew and tighten (make sure that the grubscrew is above the mounting point) . G Place pad over grubscrew. 9

G Mount crossbars over clamps.

G Ensure the pads are in the correct position and the clamp threads pass through the crossbar feet. G Place washer over clamp thread as shown. G Ensure that tab is inserted into clamp block. G Ensure the plastic knob is in the position shown when fully tightened. G Repeat for all legs. 10

G Check crossbar is securely attached to the

vehicle. G Use keys to fit and lock covers CAUTION: Recheck all fasteners immediately after a load is applied to the crossbars. Regularly check screws are tight. 11

Whispbar K807W G Clean the car roof and surfaces of the

product that will be in contact with the car roof. G Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order. G Set crossbars a minimum distance of 700mm (27 1/2") apart where no other distance is specified in the fitting instructions. This is especially important when carrying long loads. G Check unit is securely attached

G Check and replace worn out or defective

parts. G Keep the product clean and maintained. G Never drive into a car wash with the roof rack system fitted. G Lubricate locks and adjusting screws at regular intervals. G Remove the products from the vehicle when not in use. Make sure all loose parts are stored safely. G Yakima Australia Pty Ltd 17 Hinkler Court Brendale QLD 4500 AUSTRALIA www.whispbar.com.au www.whispbar.co.nz www.whispbar

WARRANTY & DISCLAIMER

Yakima Australia Pty Ltd ABN 58 154 440 221 17 Hinkler Court, Brendale QLD 4500 Tel: 0800 4776 722 (NZ) or 1800 143 548 (AU) Email: [email protected] or [email protected] Where the product is supplied to the customer for other than business purposes within the meaning of section 43 of the New Zealand Consumer Guarantees Act 1993, the provisions of that Act shall apply. It is important that anyone who fits

Alternately, you can write to Yakima at 17 Hinkler Court, Brendale QLD Australia 4500 in order to make a claim under your

warranty. Upon contacting Yakima directly, you should explain as fully as possible the defect. A Yakima representative will provide you with appropriate instructions for returning the product together with a copy of the original purchase invoice or receipt to Yakima. The costs and expenses associated with making a claim under your

Whispbar Automobile Accessories Owners Instructions: