Whispbar K687W Fitting Instructions For Basic Carrier

Text of Whispbar K687W Fitting Instructions For Basic Carrier

Fitting Instructions for Basic Carrier

x 2 x 4 x 4 x 4 x 2 x 2 x 2 Revision No: 1A 1

MAX kgs (lbs)

W/P WHD Holden Barina Spark, 5dr Hatch 10-+ NZ 50 kgs (110 lbs) 50 kgs (110 lbs) Barina Spark, 5dr Hatch Oct 10-+ AU 50 kgs (110 lbs) 50 kgs (110 lbs) Chevrolet Spark LS/LT, 5dr Hatch 10-+ EU 50 kgs (110 lbs) 50 kgs (110 lbs) Spark Campus, 5dr Hatch 10-+ ZA 50 kgs (110 lbs) 50 kgs (110 lbs) Spark EV/1LT/LS, 5dr Hatch 13-+ US 50 kgs (110 lbs) 50 kgs (110 lbs) 2

First Time Installation

G Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. G This kit fits type A, B, C and D. G These instructions show type A crossbar fitted. They also apply to type B, C and D. NOTE: Clamp images in these instructions may not be representative of the clamps in this kit 3

G Use keys to remove covers.

G Use hex screwdriver to reverse adjusting screw 10 turns. G Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment method. G Ensure each end of the crossbar is adjusted equally. 4

G Remove locking screw.

G Apply protective strip as shown. Trim if required. G A = Clear B = Grey G It is important to put the clamps in the correct position on the vehicle. G Letters refer to the part numbers stamped on clamps. G Clamp Part Number: A = 980A B = 981A 5

G Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on the vehicle (For example; "Front Right"). G Refit locking screw so that it goes through the hole in the clamp. Do not begin to tighten the locking screw. G Place rubber pads (supplied with fitting kit) on the vehicle roof. Pad may vary in shape to that shown. 6

G Make sure the pad fits into the holes

underneath the foot. Fitment G Place crossbar on vehicle. Minimum recommended spacing between the bars is 700mm (27 1/2") (unless otherwise stated). G Clamps directly to edge of roof under the doors G Please check the rear of this manual for information relating specifically to your vehicle. G Press adjusting screw to adjust the leg positions on the crossbar. 7

G Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight. G Tighten locking screw on both legs evenly. G Check crossbar is securely attached to the vehicle. 8

G Use keys to fit and lock covers

CAUTION: Recheck all fasteners immediately after a load is applied to the crossbars. Regularly check screws are tight. 9

G Clean the car roof and surfaces of the

product that will be in contact with the car roof. G Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order. G Set crossbars a minimum distance of 700mm (27 1/2") apart where no other distance is specified in the fitting instructions. This is especially important when carrying long loads. G Check unit is securely attached whenever y

Whispbar Automobile Accessories Owners Instructions: