Whispbar K522 Fitting Instructions For Basic Carrier

x 4 x 1 x 1 x 2 x 4 x 2 x 2 Revision No: 2C 1 ...

W/P WHD Hyundai ix35 , 5dr SUV 10-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs) ix35 , 5dr SUV 10-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs) ix35 , 5dr SUV 10-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs) ix35 , 5dr SUV 10-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs) 2 ...

G Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. G This kit fits type A, B, C and D. G These instructions show type A crossbar fitted. They also apply to type B, C and D. NOTE: Clamp images in these instructions may not be representative of the clamps in thi ...

G Use hex screwdriver to reverse adjusting screw 10 turns. G Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment. G Ensure each end of the crossbar is adjusted equally. 4 ...

G Apply protective strip as shown. Trim if required. G A = Clear B = Grey G It is important to put the clamps in the correct position on the vehicle. G Letters refer to the part numbers stamped on clamps. G Clamp Part Number: A = 715A B = 716A 5 ...

may have labels showing their positions on the vehicle (For example; "Front Right"). G Refit locking screw so that it goes through the hole in the clamp. Do not begin to tighten the locking screw. G Refer to the underside of the pad for the part number. 6 ...

position on the vehicle. G Letters refer to the pad part numbers and position. G Pad Part Number: A = 11-04-256 B = 11-04-257 C = 11-04-244 G Fit rubber pads (supplied with fitting kit) to foot. Pad may vary in shape to that shown. G Make sure the pad fits into the holes underneath the foot ...

doors G Please check the rear of this manual for information relating specifically to your vehicle. G Place crossbar on vehicle. Minimum recommended spacing between the bars is 700mm (27 1/2") (unless otherwise stated). G Adjust the legs on the crossbar so that they are positioned equall ...

G Check crossbar is securely attached to the vehicle. G Use keys to fit and lock covers 9 ...

a load is applied to the crossbars. Regularly check screws are tight. 10 ...