TypeS AC530013 Operation & User’s Manual

Text of the manual

5.94 × 3.3 × 1.26 in (151 × 84 × 32 mm)

0.96 lbs (434g) Lithium-Ion Up to 8000mAh (3.7V) 29.6 Wh 5V 2A 5V 2.4A 9V 2A / 5V 2.6A 10W (max.) 200A - 350A -20ºC ~ 34ºC (-4ºF ~ 93ºF) -20ºC ~ 40ºC (-4ºF ~ 104ºF) Avg. Temp. 0ºC ~ 40ºC (32ºF ~ 104ºF) 4-5 hours IP64 Splash-Resistant (w/ Ports Covered) Product Dimensions: Product Weight: Internal Batt

12V USB Charger &

Micro USB Charging Cable Storage Case Safe & Smart Jumper Cables Press the Mode Button to check the capacity of the Jump Starter. CHECKING THE POWER LEVEL NOTE: Fully charge the Jump Starter upon receipt. Check battery status periodically and recharge every 2-3 months and after every use to mainta

Press the power button once to enable

wireless charging function. Place the device on top of wireless charging icon to start. LCD screen is ON while wireless charging is in progress. The power level will vary during charging. You may need to adjust the orientation to have the best charging. NOTE: The wireless charging feature only works on devices that all

1. Press the Mode Button to power on the

Jump Starter; ensure the power level is 50% or higher. 2. Insert the GRAY end of the Jumper Cables into the Jumper Cables Port. The LCD Display will read: Clamp cables to battery. JUMP STARTING: BEFORE YOU JUMP START! Before you attempt to jump start your vehicle, ensure your vehicle is in Park. Ensure ma

JUMP STARTING CONT.:

3. Connect the RED clamp to the POSITIVE (+) post on the car battery. The POSITIVE battery post will be slightly larger than the NEGATIVE post, and will be marked with a PLUS (+) sign. There may also be a RED plastic protective cover over the positive battery post. 4. Connect the BLACK clamp to the NEGATIVE (-) post on the ca

The engine should start if there are no other problems (such as a bad

starter or ignition circuit problem). Do not attempt to jump start the vehicle more than 3 times with the Jump Starter. If the vehicle fails to start after 3 attempts, it is likely due to alternative reasons that should be checked by an auto mechanic. 7. When the engine starts, the LED o

Message on LCD Screen

Message Meaning Low Power, charge at least 50% Jump Starter battery below 50% Battery Protected, Unplug, Start over Wrong connection Device is too hot, Cool before use Temperature of jump starter is above 55°C JUMP STARTING CONT.: Polarity Protection Circuit Status Solid LED On Flashing LED LED Off Status (Light & Sound Indica

Turn on the jump

starter Press the Mode Button Switch language to Spanish Press and hold the Mode Button for 5 seconds until the word “English” is shown on the LCD screen, then press button once to enter Spanish mode. LED light remains on from 3s till 5s, light turned off when the word “English” is shown on the LCD screen. R

Other Remote Starter Manuals