Premier Mounts AM100 Installation Manual

2620 Palisades Drive, Corona, CA 92882 USA INSTALLATION GUIDE AM100 Low-Profile Ultra-Slim Swingout Mount for Flat-Panels 9531-100-001-0X v4.0 publ. 03/25/19 Maximum Flat Panel Weight: 100 lb. / 45.5 kg. ...

Page 2 INCLUDED COMPONENTS TOOLS FOR INSTALLATION 5/16” x 3” Lag Bolts (Qty 4) Green Level (Qty 1) Universal Spacers (Qty 8) 5/16” Flat Washers (Qty 4) Universal Washers (Qty 4) Depth Measuring Straw (Qty 1) 10mm Socket (Qty 1) M4 Allen Key ( ...

! Page 3 CHANGING THE DEFAULT SWINGOUT PIVOT POSITION M2.5 Allen Key Left (default) Mid Right 1 3 4 Loosen the eight flat screws to disengage the upper and lower chassis. Put together the mount after adjusting the swing pivot position and recap the ...

1 2 Page 4 Find the center of the wood studs and mark the wall with a pencil Position the template to the desired location. Drill into 4 marked mounting points on the wall surface. Wood Application: Use 1/4” drill bit Concrete Application: Use 3/ ...

3 4 Page 5 LOOSEN THE (2) M5 FLAT SCREWS TO REMOVE THE BRACKET MOUNT PLATE DETACH THE CABLE ACESS COVERS TO EXPOSE THE MOUNTING LOCATIONS ...

5 Page 6 Wood Application Concrete Application LEVEL LEVEL 4 3 2 1 (4) 5/16” x 3” Hex Lag and (4) 5/16” Washers Finned Anchor (supplied) for concrete only Use 3/8” Concrete Drill Bit Use 13mm or 1/2” Socket Wood Studs Confirm the placemen ...

6 7 Page 7 Small Straw or Toothpick Marking the 1/8” Allowance Small Straw or Toothpick Small Straw or Toothpick Depth Plus 1/8” Allowance Mark Depth Plus 1/8” Allowance Mark 1) Insert a small straw or toothpick into the threaded inserts foun ...

8 Page 8 M8 M5, M6 M4 x4 INSTALL THE MOUNTING BRACKETS USE ADDITIONAL UNIVERSAL SPACERS TO FILL UNEVEN GAPS Longer screws length (commercially available) might be needed if using spacers. Directional arrows on the brackets pointing up TOP OF FLAT P ...

9 10 Page 9 HOOK THE DISPLAY BRACKETS TO THE MOUNT POST-LEVELING (RETRACTED POSITION) Post leveling control adjustment screws. Tighten these screws to lock the brackets in place. Center the display to the mount ...

11 12 Page 10 Use 10mm deep socket to adjust the tension Use 2.5mm hex key to adjust the tension near the pivot. Do not over tighten. TILT ADJUSTMENT ROUTE POWER AND SIGNAL ALONG THE MOUNT ...