SICK GSE2 Flat Side Operating Instruction
Text of SICK GSE2 Flat Side Operating Instruction
B E T R I E B S A N L E I T U N G
GSE2 Flat Side
Miniatur-Lichtschranke
de
en
es
fr
it
ja
pl
pt
ru
zh
O P E R A T I N G I N S T R U C T I O N
GSE2 Flat Side
Miniature photoelectric sensors
de
en
es
fr
it
ja
pl
pt
ru
zh
SICK Product Center Asia Pte. Ltd.
Singapore
www.sick.com.sg
Legal information
This work is protected by copyright. Any rights derived from the copyright shall be
reserved for SICK AG. Reproduction of this document or parts of this document is
only permissible within the limits of the legal determination of Copyright Law. Any modi‐
fication,
General safety notes................................................................................
5
2
Notes on UL approval...............................................................................
5
3
Intended use.............................................................................................
5
4
Operating and status indicators..............................................................
5
5
Mounting........................
General safety notes
■
Read the operating instructions before commissioning.
■
Connection, mounting, and configuration may only be performed by trained
specialists.
■
2006/42/EC
NO
SAFETY Not a safety component in accordance with the EU Machinery Directive.
■
Do not install the sensor at locations that are exposed to direct UV radiation
(sunlight) or other weather influences, unless this is expressly permitted in the
operating instructions.
■
LED indicator green: supply voltage active
2
Receiver: LED indicator yellow: status of received light beam
5
Mounting
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
The minimum distance between sender and receiver is:
•
GSE2F(S)-xxx1xx: 24 mm
•
GSE2F(S)-xxx2xx: 72 mm
•
GSE2F(S)-xxx5xx: 238 mm
NOTE
Swap the sender and receiver ar
Plug connection: note pin assignment: when the lid is open, the male connector
can be swiveled horizontally and vertically.
–
Cable: wire color
Only apply voltage/switch on the voltage supply (UV > 0 V) once all electrical connec‐
tions have been established.
Explanation of the connection diagram (Tables pin assignment):
Q = switching outputs
n. c. = not connected
DC: 10 ... 30 V DC
Table 1: Pin assignment
GE2F(S)
-X14xx
-X54xx
1
BN
+ (L+)
+ (L+)
2