Waters 61164 Installation Manual

Text of the manual

Installation Guide / Guide d’installation

DISTRIBUTED BY / DISTRIBUÉ PAR PB with diverter/ Pression équilibrée avec déviateur #61164 / #61166 / #61168 NPT/sweat connection – PEX connection – WB connection Raccordement NPT/soudé – Raccordement PEX – Raccordement WB #61164 NPT/sweat c

DISTRIBUTED BY / DISTRIBUÉ PAR

CONGRATULATIONS ON THE PURCHASE OF YOUR PRODUCT FÉLICITATIONS POUR L'ACHAT DE VOTRE PRODUIT We recommend the installation of this product to be done by a licensed plumber. Please take a moment to read the following instructions and keep this document for future reference. We hope this product will

DISTRIBUTED BY / DISTRIBUÉ PAR

VALVE COMPONENTS COMPOSANTS DE LA VALVE 1 3 2 SPECS AT LARGE / SCHÉMA DES PIÈCES 1- ALT76061100: Deverter/Déviateur 2- ALT760705SS: Check valve / Valve d'arrêt 3- ALT760703: Cartridge holder/ manchon de cartouche 4 ALT76010100 + ALT76010200: Extension kit (sold separately) / Kit d’extension (

DISTRIBUTED BY / DISTRIBUÉ PAR

Min.[43.00] 1 11/16” Max.[67.00] 2 5/8” [48.00] 1 7/8” Min.[35.10] 1 3/8” [43.84] 1 3/4” [130.00] 5 1/8” [54.00] 2 1/8” [47.83] 1 7/8” [140.00] 5 1/2” GENERAL DIMENSIONS DIMENSIONS GÉNÉRALES BEFORE YOU START AVANT DE COMMENCER CAUTION: FOR BEST RESULTS, WE STRONGLY RECOMMEND TH

DISTRIBUTED BY / DISTRIBUÉ PAR

How to Use the Plastic Protector Cap The valve is covered by a plastic protector cap. It can be used as a template for setting the depth of the valve in the wall. The finished wall can fall anywhere along the side of this plastic cap (Fig.1). The protector cap will also be used as a template to cut

DISTRIBUTED BY / DISTRIBUÉ PAR

Installing the valve Once the mixer location is determined, position the valve in between 2x4 studs inside the wall on a plywood backing for better support. (Fig. 3) Make sure the valve is level and at the right depth before securing it firmly in place. Intallation de la valve Une fois l'emplacemen

DISTRIBUTED BY / DISTRIBUÉ PAR

(A) (B) UP DOWN COLD WATER EAU FROIDE HOT WATER EAU CHAUDE Connecting the water Connect the hot and cold water inlets and the mixed water outlets (Fig. 5). The hot water must always be connected on the left side and the cold water on the right, as indicated on the valve body. Ensure the piping is fr

DISTRIBUTED BY / DISTRIBUÉ PAR

1 4 6 3 2 5 The highest temperature needs to be set at or under 120°F (49°C). It can be adjusted as follows: remove the decorative cap (1), the set screw (2), the handle (3) and the dome cap (4) (Fig. 6). Pull out the temperature limiting ring (5) from the cartridge (6). Gradually rotate it to the

More Waters Control Unit Owners Instructions: