Sharp LC-15A2M Service Manual

to its original condition and only parts identical to those specified should be used. MODEL LC-15A2M LCD COLOUR TELEVISION CONTENTS Page » IMPORTANT SERVICE SAFETY PRECAUTION ....... 2 » SPECIFICATIONS ................................... ...

AGAINST A RISK OF FIRE REPLACE ONLY WITH SAME TYPE FUSE. F3701 (1.25A, 250V), F3702 (1.25A, 250V), F3751 (2.0A, 250V) FUSE. 12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212 12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678 ...

AC 110-240V (AC Adapter) Power Consumption .............................................................. 27 W (Connected to DC 12V) LCD Panel Size ................................................................ ...

Main unit (rear view) Remote control Power/standby indicator A green indicator lights when the power is on and a red indicator lights when in the standby mode (the indicator will not light when the main power is off). Rear control panel Remote sensor window (The actual location is not visible) To change the ...

5 LC-15A2M Dimensions Units: mm 1.5 341.4 310.6 138.7 ø 205.0 231.1 307.4 359.0 357.0 45.3 30.3 1.5 156.4 114.5 50.0 46.4 26.0 339.2 124.1 121.1 4.5 66.0 3.0 2.75 12 12 12 12 12 14.0 14.0 14.0 14.0 14.0 14.0 14.0 14.0 14.0 13.0 14.0 35.5 3.0 ...

1. Insert your finger into the center of the terminal cover and pull it toward you to detach the terminal cover. 2. Remove the four screws 1 and one screw 2. 3. Open the cabinet B by approx. 45˚ from the bottom of the cabinet (stand side). 4. Remove the lead wire from the cable clamp 3. 5. Remove the power connector 4. 6. ...

1. Remove the six LCD unit fixing screws. 2. Remove the shield case. 3. Remove the light guide panel holder. 4. Remove the reflection panel. 5. Remove the lamp unit. 6. Remove the light guide plate. 7. Remove the fixing angle. 8. Remove the ITO sheet, diffusion sheet and the reflection polarizing sheet. » Caution for ...

The best adjustment is made before shipping. If any position deviation is found or after part replace is performed, adjust as follows. 1. Preparation for Adjustments (1)Use the exclusive-use AC adapter or stable DC power supply. AC adapter: UADP-0210CEZZ DC power supply: 12 ±0.5V 2. Special mode setting procedu ...

Turn off the main power. 4. Adjustments 5. Shipping setting list Channel............................................................................................................................................... 1ch Skip Data ............................................................................................. ...

No picture at all Yes No Are inputs and outputs of IC802 as specified? Check all the settings on the microprocessor’s adjust process menu. No picture Check IC802 and its peripheral parts. Yes No Are inputs and outputs of IC1201 as specified? Check IC1201 and its peripheral parts. Check LCD panel voltage and waveform. No T ...