Tracker PRO Series Manual 

IL-TRACKER575S/1 V1.3 This manual contains important information. Please read before operating fixture. ...

Limited Warranty: This warranty covers defects or malfunctions in this equipment. This warranty lasts for a period of one year from date of purchase. It is the owner’s responsibility to provide invoices for proof of purchase, purchase date and dealer ...

Specifications .............................................................................................................................5 Fixture Overview .......................................................................................................................5 Physical.................................................... ...

• Tilt range of movement: 280 degrees • High resolution 16 Bit Pan/Tilt movement for accurate positioning • Pan/Tilt motor speed • Consistent & auto correcting Pan/Tilt positioning • Color wheel with 9 dichroic colors plus open • Color wheel with continuous rotation for rain ...

105°F (40°C) Maximum exterior surface temperature 176°F (80°C) Minimum distance to flammable surface 3.3ft (1m) Minimum distance to illuminated surface 4ft (1.2m) Electrical Factory Setting 120v 60Hz Selectable Voltages 100v / 115v / 208v / 220v @ 50 or 60Hz Rated Power 850W, 7A @ 120v Fuses 15A Time Delay (Slo ...

11 - Enter-button 12 - Up-button 13 - Down-button 14 - Display Rear panel: 5 - Power switch 6 - DMX output 7 - DMX input 8 - Power cord 9 - Fuse holder 1 - Moving head 2 - Yoke 3 - Carry handles 4 - Base ...

present and have been received in good condition. If any parts appear damaged from shipping or the shipping carton shows signs of mishandling, retain all packing material for inspection and notify the shipper immediately. Save all original packing an ...

For protection against electric shock, fixture must be connected to suitable earth ground. Make sure fixture is cool and disconnected from power mains before any service. The listed current rating is its average current draw under normal conditions. All fixtu ...

Do not touch the lamp glass with bare fingers. Wear eye protection when handling lamp. When operating, always allow the lamp to cool at least 5 minutes before attempting to re-strike the lamp. Not doing so can cause damage to the fixture and lamp. This fixture uses a 57 ...