Walker Edison BKMCPLAT Assembly Instructions Manual

Text of Walker Edison BKMCPLAT Assembly Instructions Manual

Insert wooden dowels (E) into rails (4,,9,10)

J J J J J J J J Attach legs (3) to cross bar (4) using bolt (A) and heex key (J)

Secure part (4) to part (8,9) using bolt (A) and hex key (J)

Connect parts (8,9) to parts (10,11) Secure parts with screw (O) O O O O O O

Secure parts (10,11) to parts (8,9) with screw (A) and hex key (J)

J Attach Feet (12) to frame parts (10,11) using screw (M) and Union Screw (N). Union Screw (N) Should be on the inside of the bed frame, with screw (M),on the outside of the leg. Tighten by using with hex key(J) on both ends of the screw at the same time. The use Screw (D) and hex key (J) to secure legs(12). J J M N J M N J J

P P P

P Q Q P 20mm 30mm Secure feet to frame using screw(C). Attach the metal connector plate (Q) to the 2 corners of the bed with screws (P). Take care to aligne the plate over the sean of the two parts, as shown in the drawing, before seguring in place. Start slats assemble with slat spacer (L) 30mm B Secure slat (11) Using Screw (B) and slat spacer (L) L L

Walker Edison Indoor Furnishing Owners Instructions: