Sharkoon TAREA Manual 

Text of Sharkoon TAREA Manual 

Handbuch Manual Manuel d‘utilisation Guia usario Manuale d´istruzioni Gebruiksaanwijzing Guia usário Instukcja obstugi 使用手冊 ユーザー マニュアル

The case at a glance

4. Installation of a mainboard 5. Installation of a PSU 6. Installation of a HDD 7. Installation of an optical device 8. Installation of a 3.5" device 9. Installation of an add-on card 10. Installation of additional fans / optimized airflow Dear customer! Congratulations for purchasing this premium quality SHARKOON product. For a long life time and to take full advantage of this product

•� Top� I/O� with� 2x� USB2.0,� 1x� eSATA,� 1x� headphone� and� 1x� microphone� connector,�

power and reset button � •� 7�slots�for�add-on�cards � •� Black�interior�painting � •� Front�bezels�in�mesh�design � •� Quick�fasteners�for�optical�drives,�mainboard�mounting�with�installation�op

5.25" bezel with 3.5" opening

Note: If you are missing any of the items listed above, please contact our customer service immediately: [email protected] (Germany and Europe) [email protected] (international). A B

3. The case at a glance

Front view A� –��LED�for�HDD�activity B��–��5.25"�drive�bays C��–��behind�the�mesh�bezel:�120�mm�fan�bracket View from above Front�panel: A – Power and B��–��Reset�button Case�top: C��–��Top�I/O�with: � � a��–��1x� headphone� and� microphone� connector � � b��–��2x�USB2.0�and� � � c��–��

A – Drive bays for 5.25" devices

B��–��Mainboard�mounting�panel�with: a – Installation opening for CPU coolers and b – Cable management system Back�side A – Opening for I/O shield B��–��120�mm�fan�bracket C – Slot bezels D – Openings for water cooling E – PSU bracket F – Thumb screws Bottom�view A – Case feet B��–��Air�intake�for�PSU a

For more information on how to install the intended devices, refer to their respective

documents. 4. Installation of a mainboard 1. Open the case by loosening the thumb screws on the case’s back side and removing the left � side�panel.�Lay�down�the�case�sidewise�on�an�even�surface. 2.��The� mainboard’s� mounting� panel� inside� the� case� provides� various� drillings� to� fix� the� � st

Place the mainboard to the mounting panel. A stand-off must be screwed into every drilling

of the mounting panel visible through the mainboard’s screw openings. 3. Remove the mainboard and screw the stand-offs into the respective drillings of the � mounting�panel�(fig.�3). � (Stand-offs) � fig.�3 4.��Press�the�I/O�shield�(delivered�with�the�mainboard)�into�the�I/O�shield�opening�in�the�case’s� bac

6. Plug the connectors of the case’s front bezel to the respective connectors of the mainboard

� (also�refer�to�your�mainboard’s�manual�for�further�information). Note: The eSATA cable connected to the front eSATA connection should not exceed 50 cm of length otherwise transmission errors may occur! With premium quality eSATA cables this maximum length may be exceeded. 5. Installation of a PSU 1. Set up the case in front of you

Sharkoon Enclosure Owners Instructions: