Wacker Neuson ST11 Operation & Maintenance Manual

MANUAL Compact Track Loader ST11 Item 8009641121 Revision Date 101 March 2022 ...

The manual was created and formulated in conformity with the EEC regulations and in particularwith the UNI-ISO 6750 regulation. The manual supplies information about the operation of the machine, with particular reference tothe safety procedures to adopt d ...

Item – Rev(s): 8009641121– 101 Table of Contents 01 02 03 04 05 PRESENTATION OF THE MACHINE GENERAL SAFETY REGULATIONS OPERATER CONTROLS EQUIPMENT AND ACCESSORIES MAINTENANCE 4 10 15 29 34 ...

The loading shovel has been designed and built for loading and unloading earth, gravel, sand, debris and other loose material and is however suitable to operate in compliance with the features and performance indicated in this manual. It is a machine with Diesel internal combustion motorisation with hydrostatic transmission ...

Item – Rev(s): 8009641121– 101 TECHNICAL DATA ENGINE Brand and model Kubota V1505T Calibration Power at 2800 rpm HP/Kw 41/30 Cylinders Nº 4 Displacement cm3 1498 Cooling water HYDRAULIC SYSTEM: Hydrostatic drive with double axial piston pump and variable cylinders connected to two two- speed geared motors, one for each track roller. Negativ ...

LOADING WITH RAMPS AND TRANSPORT BY TRUCK The machine loading and unloading operations must be carried out on a compact and level surface. Check that the transport vehicle is in perfect condition. Apply the hand brake and insert safety wedges at the front and rear of the rear axle tyres. The vehicle engine must be of ...

hydraulic oil at operating temperature. Do not use the ramps as a gangway for crossing from one vehicle to the next. For loading and unloading of the machine it is recommended to ascend in reverse gear and descend in forward gear. In both cases it is recommended to ...

infiltration of water could seriously damage the electrical system of the right-hand and left-hand dashboard. Restrict the liftingarea, prohibiting access to foreign personnel. Do not pass over persons or things and ensure that the loading area is free of any obstacles (ele ...

arms is prevented by the hydraulic block inserted on start-up of the machine. - Disconnection and insertion is controlled by a button (ref. 4) on the right command panel. - Obligation for approved yellow flashing light. This functions even when the use of a lighting device is not ...

The plates applied, other than indicating the various manoeuvres for machine control and use, serve to point out the risks connected with machine operation. An operator who wears glasses mustuse them to read the plates. Keep all the plates clean and legible paying particular attention to the safety warnings indicated. Replac ...