Secukey S2-MF Operation & User’s Manual

1.1 FEATURES .............................................................................................................................. 1 2. SPECIFICATIONS .................................................. ...

proximity entry for up to 1000 users. It uses Atmel microcontroller assures maximum performance in any environment, and the low-power circuit makes its service life prolonged. The product unique feature is simple in design, easy operation, and hi ...

3. INSTALLATION  Remove the back cover from the unit  Drill 2 holes (A,C) on the wall for the screws and one hole for the cable  Knock the supplied rubber bungs to the screw holes(A,C)  Fix the back cover firmly on the wall with 4 flat head screws  Thread the cable through the cable hole (B)  Attach the unit to the ba ...

Black GND Ground White NO Normally Open Relay Output Brown COM Common Connection for Relay Output Green NC Normally closed Relay Output Yellow OPEN Request to Exit input(REX) 3.2 Sound and LED Status Indicators Operation Status LED Buzzer Stand by Solid Red - Enter into progr ...

Common power supply: Attention: Install a 1N4004 or equivalent diode is needed when use a common power supply, or the reader might be damaged. (1N4004 is included in the packing) ...

5. Master Cards Usage Using Master Cards is the easiest way to add or delete cards. Add Card User 1. (Read Master Add Card) 2. (Read User Card) Repeat Step 2 for additional user cards 3. (Read Master Add Card) to stop adding. Note: Same User Card cannot add more than once. ...

1. (Read Master Delete Card) 2. (Read User Card) Repeat Step 2 for additional user cards 3. (Read Master Delete Card) to stop deleting. 6. Programming Programming will vary depending on access configuration. Follow the instructions according to your access configuration. General Programming Information  Remote Control: Please use the In ...

* (Master Code) # Add Card User 2. Add Card: Using Auto ID (S2-MF reader will automatically assign the next available User ID number to Card) 1 (Read Card) # The cards can be added continuously. For example: 1 (Read Card1)(Read Card2)...# Note: After read card, Card link to an available User ID number. OR 2. Add Card: Using User ID (M ...

OR 2. Latch Mode 3 (1-99) # The relay time is 1-99 seconds. (1 is one second) (Default is 5 seconds) 3 0 # Sets the relay to ON/OFF Latch mode. (If door closed, after read valid card, door will open and remain in open state; only read valid card again – not necessary the same card, the door will close) 3. Exit * 6.5 Set ...