Perlesmith PSTVS18 Instruction Manual
Text of the manual
Table Top TV Stand Instruction
Manual
V1.0
Thank you for choosing this PERLESMITH product! At PERLESMITH we
strive to provide you with the best quality products and services in the
industry. Please share your experience of our product with others at
www.perlesmith.com/pages/reviews if you are satisfied. Should you have
any issues, please don'
IMPORTANT SAFETY INFORMATION
Please carefully read all instructions before attempting installation. If you do not
understand the instructions or have any concerns or questions, please contact
our Technical Support line at 1-800-556-6806 or customer service at
[email protected] (US)/ [email protected] (CA).
CAUTION: Avoid potential personal i
WARNING: This product contains small items that could be a choking
hazard if swallowed.
Before starting assembly, verify all parts are included and undamaged. Do not
use damaged or defective parts. lf you require replacement parts, contact our
Product Support line at 1-800-556-6806 or customer service at
[email protected] (US)/ supportca@perles
Note: The bolts and spacers are shown in accordance with the actual size
Supplied Part and Hardware for Step 3
Supplied Parts and Hardware for Step 4
x2
TV Bracket
06
(M-G) x4
D8x18x1.5
Wash
Place rubber feet [A] to the tempered glass base [01] in the
corners
Note: Kindly note that the tempered glass base is designed to show the
shiny glass side facing up
Step 1-1
Connect the lower support pillar [02] to tempered glass base [01]
Step 1-2
P4
Secure the lower support pillar [02] to tempered glass base [01] using plastic
cover [07], washers [C], pl
Step 2 Connect the Upper Support Pillar [03] to Lower Support Pillar [02]
Note: There are two choices for height adjustment. You can choose your
desired height position while connecting the TV plates [05] to upper support
pillar [03]
The First Choice
The Second Choice
Step 3 Connect the TV Plates [05] to Upper Support Pillar [03]
E
G
02
03
H
Please do not firmly tighten the 4pcs
bolts [E] in this step.
Insert the other TV plate into the TV plate connector, then insert the other
4pcs bolts [E] into the TV plate. Finally secure the TV plates to upper
support pillar by tightening the 8pcs bolts [E]
H
H
Bolt length: Verify adequate thread engagement with bolts or bolts/spacers
combination. We recommend thread engagement by at least 5 turns.
-Too short will not hold the TV.
-Too long will damage the TV.
Please Note: The provided TV bolts meet most of today’s TVs design.
However, some TVs require special bolts which may
Option B (For Round Back TV)
M-F
M-I(If needed)
M-G
M-A/M-C
M-F
M-B/M-D/M-E
M-H/M-I
M-G
Note: Keep
the arrow up
Note: Keep
the arrow up
Option A (For Flat Back TV)
M-G
M-G
The spacers must be used with washers [M-G] to stop spacers from falling down.
Alternate Spacer
Setups
The spacers must be used with washers [M-G] to stop spacers from falling down.