Texas Instruments TPD2E2U06-Q1EVM Operation & User’s Manual

module (EVM). This EVM includes 7 TPD2E2U06-Q1’s in various configurations for testing. Five TPD2E2U06-Q1’s are configured for IEC61000-4-2 compliance testing, one TPD2E2U06-Q1 is configured for 4-port ...

Contact Discharge Air Discharge Class Test Voltage [± kV] Class Test Voltage [± kV] 1 2 1 2 2 4 2 4 3 6 3 8 4 8 4 15 Table 3. Waveform Parameters in Contact Discharge Mode Stress Level Step Simulator Voltage Ipeak ±15% [A] Rise Time ±25% Current at 30ns Current at 60ns [kV] [nS] ±30% [A] ±30% [A] 1 2 7 ...

network analyzer. Connect Port 1 to J1, Port 2 to J2, Port 3 to J3, and Port 4 to J4. This configuration allows for the following terminology in 4 port analysis: • S11: Return loss • S21: Insertion loss • S31: Near end cross ...

Connect the tested device on the EVM to a curve tracer both before and after ESD testing. After each incremental level, if the IV curve of the ESD protection diode shifts ±0.1V, or leakage current increases by a factor of ten, then the device is permanently damaged by ESD. 3.4 U6 A TPD2E2U06-Q1 (U6) also has ...

FR-4 at 0.062” thickness. Layers 2, 3 and 4 are identical. Figure 3. TPD2E2U06-Q1EVM Top Layer 5 SLVUAC6–December 2014 TPD2E2U06-Q1EVM Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated ...

6 TPD2E2U06-Q1EVM SLVUAC6–December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated ...

5 Schematics and Bill Of Materials 5.1 Schematics Figure 5. TPD2E2U06-Q1EVM Schematic 7 SLVUAC6–December 2014 TPD2E2U06-Q1EVM Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated ...

www.ti.com Table 4. Bill of Materials Count RefDes Description Size Part Number MFR 7 U1-U7 IC, 2-channel ESD solution 0.063 x 0.048 inch TPD2E2U06-Q1 TI 4 Connector, SMA, Plug SMA Limited J1-4 0.25 X 0.375 inch 142-0701-231 Emerson Detent SMP-P/PCB 2 J5-6 Connector, USB,TYPE A Female 0.52 X 0.55 inch 87583-2010BLF FCI 2 J7 C ...

1. Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, or documentation (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms and conditions set forth herein. Acceptance of the EVM is express ...

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate ra ...