Philips BT50A Operation & User’s Manual

Register your product and get support at Question? Contact Philips Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Philips BT50A o cerca il tuo prodotto tra le migliori offerte di Diffusori Audio ...

3 Introduction 3 What's in the box 3 Overview of the speaker 3 3 Get started 4 Charge the built-in battery 4 Turn on/off 4 4 Play from Bluetooth devices 5 Connect a device 5 Disconnect a device 5 Reconnect a device 6 5 Play from external devices 7 6 Product information 8 Amplifier� 8 Speaker 8 Bluetooth 8 ...

• Never lubricate any part of this product. • Never place this product on other electrical equipment. • Keep this product away from direct sunlight, naked flames�or�heat. • Read these instructions. • Heed all warnings. • Follow all instructions. • Do not use this appa ...

speaker Congratulations on your purchase, and welcome�to�Philips!�To�fully�benefit�from�the� support that Philips offers, register your product at www.philips.com/welcome. Introduction With this speaker, you can enjoy audio from Bluetooth-enabled devices or other external devices. What's in the box Check and identify the ...

Always follow the instructions in this chapter in sequence. Charge the built-in battery The speaker is powered by a built-in rechargeable battery. Note • Before use, fully charge the built-in battery. • The micro USB socket is for charging only. • It takes you approximately two hours to fully charge the battery. • Rechargeable ...

Bluetooth devices With this speaker, you can listen to audio from Bluetooth-enabled devices. Note • The speaker can memorize a maximum of four paired devices.�The�fifth�paired�device�will�replace�the�first�one.� • Any obstacle between this speaker and a Bluetooth device can reduce the operational range. • Keep aw ...

When you turn on the speaker, it will reconnect the last connected device automatically; If not, select [Philips BT50] or [Philips BT25] on your Bluetooth device to start connection. ...

external devices With this speaker, you can also listen to an external audio device such as an MP3 player. Note • Make sure that music playback through Bluetooth is stopped. 1 Connect an audio input cable (not supplied)�with�a�3.5�mm�connector�on� both ends to • the AUDIO IN socket on this speaker, and • the headphone so ...

notice. Amplifier Rated Output Power 2W RMS Frequency Response 100 -16000 Hz, ±3dB Signal to Noise Ratio > 70 dBA Audio-in Input 300�mV�(typical)�–� 1600�mV�(Max.)�RMS Speaker Speaker Impedance 4 ohm Speaker Driver 4cm full range Sensitivity >82dB/m/W ...