multicomp pro MP720775 Manual 

1. General Safety Requirements ..................................................................................... 1 2. Safety Terms and Symbols.......................................................................................... 2 3. Quick Start ...................................................................................... ...

Before use, please read the following safety precautions to avoid any possible bodily injury and to prevent this product or any other connected products from damage. In order to avoid any contingent danger, ensure this product is only used within the range specified. Only the qualified technicians can implement ...

Safety Terms Terms in this manual. The following terms may appear in this manual: Warning: Warning indicates the conditions or practices that could result in injury or loss of life. Caution: Caution indicates the conditions or practices that could result in damage to this product or other property. Terms on the ...

Ground Clip Signal Input Electrical Outlet Probe Oscilloscope AC Adapter The diagram of the ground wire connection when the battery-powered oscilloscope is connected to the AC-powered PC through the ports: Ground Clip Signal Input Oscilloscope (Battery-power) PC Electrical Outlet Probe U ...

Introduction to the Structure of the Oscilloscope This chapter makes a simple description of the operation and function of the oscilloscope, enabling you to be familiar with the use of the oscilloscope in the shortest time. Front Panel The front panel has knobs and function buttons. Through the function buttons, you can enter d ...

knob is used to adjust trigger level of current channel. 7. The B knob: When one of the CH1 - CH4 buttons is lighted, this knob is used to adjust the voltage scale of current channel. When HOR button is lighted, this knob is used to adjust ...

flash disk needs to use this port. 5. LAN port: the network port which can be used to connect with PC. 6. Connector for the DC power source via an AC-DC adapter Top Panel Input connectors of four channels Figure 3-3 Top Panel Overview User Interface Introducti ...

"Single" trigger modes. Scan: Capture and display the waveform continuously. Stop: Data acquisition stopped. 4. Click to auto set. 5. The two blue dotted lines indicates the vertical position of cursor measurement. 6. The pointer indicates the trigger position in the record l ...

"BW" indicates bandwidth limit. The icon shows the coupling mode of the channel. "—" indicates direct current coupling "～" indicates AC coupling " " indicates GND coupling 27. The reading shows the setting of main time base. 28. The green pointer indicates the g ...