Perle eXP-xS110E Installation Manual

Version: A.1.10.01.2017 Perle Advanced Powered Ethernet Extenders Installation Guide 10/100 10/100/1000(Gigabit) eXP-xS110L eXP-xS1110L eXP-xS110E eXP-xS1110PE eXP-xS1110E ...

operation of the Perle 10/100 and Gigabit (10/100/1000) Advanced Powered Ethernet Extenders. These Ethernet Extenders enable Ethernet communication across a single pair of copper wires such as 2-wire twisted pair telephone wire or coax cable using VDSL2 technology for extended ...

Ethernet Extenders. 1. Set the Dip switches on each Ethernet Extender (if needed). See Bank 1 - Dip Switches for more information. 2. Set Power Sourcing Jumpers (If needed) (E and PE models only). 3. Connect Line cables to the Line ports. See Connecting to the Line Port for mor ...

installations, however it is recommended that one Ethernet Extender should be configured for Auto Local mode (Auto CO) and the other for Remote mode (CPE). The Dip switches are accessible through an opening on the back of the unit. NOTE: All switch changes take effect immediately and ...

symmetrical, it is usually preferable to set (via this Dip switch) one unit to Auto Local and one unit to Remote, thus forcing the roles on each unit. This will guarantee the higher bandwidth in the desired direction and may result in slightly faster training times. Remote: This Ethernet Exte ...

Switch Position Mode Up (default) 9dB Down 6dB This switch is used to configure the Signal to Noise Ratio Margin (SNR). The Ethernet Extender will attempt to maintain the desired SNR value by adjusting line settings. A larger dB number will result in less line errors and a more stable connection, but may result in slower sp ...

parameters. Ethernet AutoNeg On: When enabled, the Ethernet Extender will Auto-negotiate Ethernet Link parameters with its link partner. It will advertise capabilities of 10,100 Mbps or 10, 100, 1000 Mbps (depending on the model), full and half duplex, pause and remote fault. Ethernet Aut ...

the Ethernet interface in a down state until the VDSL link comes up. At this point, if the link is lost on the Ethernet connection, then the peer Ethernet connection will be brought down by the remote Ethernet Extender. This is accomplished by signalling Link Pass- Through across the VDSL lin ...

The 10/100 or 10/100/1000 ports (LNK) on each of the links will be turned off if the VDSL link is broken. PSE Power (Switch 3, 4) (applies to port 1 on eXP- xS110E/1110/P/E models)) These switches are used on the E and PE models to indicate the type of device detection required when connecting a PD to port 1 of the Ethernet Extend ...