Motion Composites Helio C2 Instruction Sheet

Page 1 of 4 INSTRUCTION SHEET ADJUSTING THE T-TYPE AND FLIP BACK ARMRESTS This document explains how to adjust the removable T-Type armrests and the removable and retractable flip back armrests on Motion Composites folding and rigid wheelchairs. For information on how to remove, install, tilt or adjust the height of an armrest, refer to the User's Manual. Wheelchair model(s) Tool(s) and materials required • HELIO C2/XC2/A6/A7/Kid/K • VELOCE • APEX A/C/P • CHRONOS • PLATINUM 1/2 • COBALT 1/2 • Hexagonal key (Allen key): 2 mm, 4 mm • Medium or small flat or star (Phillips) head screwdriver REMINDE ...

Page 2 of 4 INSTRUCTION SHEET ADJUSTING THE T-TYPE AND FLIP BACK ARMRESTS POSITIONING THE ARMREST RECEIVER • Loosen the two screws (4 mm hex key) on the receiver retaining ring. • They are accessible from the outside of the chair • Carefully move the receptacle on the frame tube to avoid damaging the surface • Tighten the two screws of the receiver • Apply a torque of 7 Nm to the screws • When the wheelchair is equipped with a removable and retractable "U" shaped armrest, the receiver can only be positioned where it can accommodate the armrest when folded down • Note that there are 2 types of rece ...

Page 3 of 4 INSTRUCTION SHEET ADJUSTING THE T-TYPE AND FLIP BACK ARMRESTS CHANGING THE REMOVAL MODE (FIXED OR REMOVABLE) OF A FLIP BACK ARMREST • Raise the armrest all the way up to access the screw installed on the double hook trigger (red plastic part) of the pivot arm • It is the orientation of the double hook trigger in relation to the screw that indicates whether the armrest is in fixed mode (the user cannot remove the armrest) or in removable mode (the user can remove the armrest). • Fixed mode: The double hook trigger is installed and screwed into the hole marked with a diamond • Removable mode: ...

Page 4 of 4 INSTRUCTION SHEET ADJUSTING THE T-TYPE AND FLIP BACK ARMRESTS CONVERTING A FLIP BACK ARMREST INTO A T-TYPE ARMREST • To convert a removable and retractable flip back armrest into a T-Type armrest, simply remove the pivot arm. • Refer to the User's Manual (folding wheelchairs) for assembly and disassembly instructions. • Order shorter screws so that there are no exposed threads when the pivot arm is removed • The opposite is possible (converting a T-Type armrest into a flip back armrest) only if the chair is equipped with the standard armrest model with a bidirectional lateral button height a ...