Electrolux 134700400 Installation Instructions Manual

Text of the manual

137064300 A (0801)

Installation Instructions Electrolux Front-Load Washer Instrucciones de Instalacion Lavadora de carga frontal Electrolux Instructions d’installation Laveuse à chargement frontal Electrolux

Please read and save this guide

Thank you for choosing Electrolux, the new premium brand in home appliances. These Installation Instructions are part of our commitment to customer satisfaction and product quality throughout the life of your new appliance. We view your purchase as the beginning of a relationship. To ensure our ability to

Important Safety Instructions

Recognize safety symbols, words and labels Safety items throughout this manual are labeled with a WARNING or CAUTION based on the risk type as described below: Tools and materials needed for installation: WHAT TO DO IF YOU SMELL GAS: Do not try to light any appliance. • Do not touch any electrical switch; do not use �

Electrical system requirements

Water supply requirements Grounding requirements Drain system requirements CIRCUIT - Individual, properly polarized and grounded 15 amp. branch circuit fused with 15 amp. time delay fuse or circuit breaker. POWER SUPPLY - 2 wire, with ground, 120 volt single phase, 60 Hz, Alternating Current. OUTLET RECEPTACLE - Properly gro

MINIMUM INSTALLATION CLEARANCES - Inches (cm)

SIDES REAR TOP FRONT Alcove 0” (0 cm) 0” (0 cm)* 0” (0 cm) n/a Under- Counter 0” (0 cm) 0” (0 cm)* 0” (0 cm) n/a Closet 0” (0 cm) 0” (0 cm)* 0” (0 cm) 1” (2.54 cm) Installation Requirements Clearance requirements 0” (0cm) 0” (0cm) 1” (2.54cm) 0” (0cm) IMPORTANT DO NOT INST

to clear open door

31.50” (80.01cm)* to front of closed door water supply connection on rear of unit ¹ drain hose on rear of unit ² power cord on rear of unit ³ freestand washer on floor floor line floor line washer mounted on optional pedestal 27.00” (68.58cm) * To

Removing foam packaging

Temporarily remove door tape. 1. Open washer door and remove everything from 2. the drum. Close door and reapply door tape. 3. Using a rug, blanket or piece of cardboard to 4. protect the floor, carefully lay the washer on it’s back. Remove styrofoam base and shipping plug and 5. set them aside. Carefully return t

Removing shipping hardware

Installing hole plugs NOTE Rubber expansion material on spacers may need time to relax before they can be easily pulled through shipping hole. IMPORTANT Save all shipping bolts and spacers for future use. If the washer is to be transported at a later date, the shipping hardware must be reinstalled t

Leveling your washer

Excessive noise and vibration can be prevented by properly leveling the washer. For free standing installation and with the 1. washer within 4 feet (1 m) of its final location, place a level on top of the washer. Use the universal wrench to adjust the level- 2. ing legs so the washer is level front

Run some water from the hot and cold faucets

1. to flush the water lines and remove particles that might clog the water valve screens and to determine which faucet is hot and which is cold supply. Look in the end of each water supply inlet hose 2. and verify that the rubber washers are in place. Connect the HOT inlet hose to the HOT water 3. supply and th

Other Washer Manuals