Elinchrom Ranger RX Operating Manual

Operating Manual Elinca S.A Ranger RX 01.06.2007 ENG (73300) Printed in Switzerland Battery Power Pack Ranger RX ...

The listed values are guide values which may vary due to tolerances in components used. Introduction 2 Declaration of conformity, disposal and recycling, CE marking 3 Safety notice and precaution 4 Before you start 5 Control Panel 6 Functions 7, 8 Synchronisation, Wireless Remote control and flash triggering 9 Change the battery 9 Battery charging, battery fuses 10 Flashheads connections 10 Flashheads 11 Technical D ...

demanding principles, the long experience of ELINCHROM in lighting products for the studio and the utilization of the latest technology in this area. Totally integrated to the range of the ELINCHROM flashes, the Ranger RX units maintain the traditional look and function that is ELINCHROM. Ranger RX The Elinchrom Ranger RX is manufactured by Elinca S.A. CH -1020 ...

89/336/ECC «Electromagnetic compatibility» and 73/23/ECC «Low voltage directive». Notational Conventions The meaning of the symbols and fonts used in this manual are as follows: Pay particular attention to text marked with this symbol. Failure to observe this warning endangers your life, destroys the device, or may damage other equipement Suppl ...

• For your safety, never open or disassemble your flashes. • Only an authorised service engineer should open or attempt to repair the units. • For repairs, take them to your elinchrom agent. • Internal defect charge capacitors may explode whilst the unit is in use, never switch on a not proper working flash unit. Flash Tubes and Modelling lamps • Flashtubes a ...

nience, which it may represent to others for example children. • Before you travel or transport the unit: Select the function "Auto Off" (indicated by the green Led illuminated) and switch Off the unit. This will give a maximum of security and no loss of batterry supply until transport. • If you travel by airplane remove the battery box and the fu ...

Setup 1. On/Off switch. 2. Automatic Off switch with LED indicator, if no Control is operated, the unit will switch off after 5 min.. Maximises number of flashes. 3. Slow charge with LED indicator. Saves the battery and increases the lifetime of the battery. 4. Photocell on/off switch with Led indicator. 5. Modelling lamp switch, three functions. 6. Charge Ready Beep on/off, with LED indicator. Power 7. - Power adjust ...

By pressing this touch button the Ranger RX power pack is switched on or off. Note: In the unlikely case of malfunction, please check the charge and modelling lamp fuses. Auto OFF – Function (2) If this function is switched on (indicated by the green LED) the Ranger RX power pack will switch off after 5 min with not in use. Any re-use of the unit restarts the 5 minutes waiting time, before shutting down. This Auto Off function is to s ...

This touche button activates the BEEP acoustic signal. When the LED is illuminated, 1 x Beep signal indicates that the unit is ready for operation. 3 x Beep signals indicate overheating (or defect in the charge circuit), the display (6) willshow "ER" 4 x Beep signals indicate that the unit is shutting down. To select the desired power (in 1/10 f-stops), use the touche buttons. Minimum power is 1.5 (approx ...

Connect the Sync lead with the traditional EL-synchro socket 14. To protect the synchronisation circuits of your camera, Elinchrom uses only 5 Vdc. Use only Elinchrom synchro leads, code: 11075. Charge Socket and Remote control (15) To charge the Battery, use only the Elinchrom charger Code 19293. The Ranger RX offers two charging possibilities: Connect the EL charger to the charge socket 15, or to recharge the battery externa ...

1. 30 A Auto fuse (on the top side of the Battery Box). 2. 4 AF (Quick acting / 5 x 20 mm) charge fuse (on the top side of the Battery Box) 3. 10 AF (Quick acting / 5 x 20 mm) modelling lamp fuse inside Ranger RX housing. The Battery Box must be removed before the fuse can be exchanged. 4. An additional modelling lamp fuse is in every Free Lite flashhead! Standard type 5 x 20 mm, 10 AF (quick-action). For exchanging ...

The special flashhead bayonet plug with locking ring protects against dust and humidity. The modelling lamp can be activated for 15 or 30 seconds. By pressing the switch (-on the rear of the head-) once, the modelling lamp switches off after 15 seconds, when pressing the switch twice within 2 seconds, the modelling lamp will switch off after 30 seconds. To switch of ...

- - - Control range f-stop 1,5 - 7,5 - - - F-stop, 1m, 100 ISO, with reflector 48° - 64 64 32,5 Recycling time fast @ Min/Max power s 0,5 - 5,5 - - - Recycling time slow @ Min/Max power s 0,9 - 14 - - - Flash duration @ t 0,5; 1 A and 2 A heads s - 1/1150 1/2250 1/2300 1/4310 1/675 1/1680 Flashes, out of one charged Battery @ Min/Max Power, slow/fa ...

26143 Compact ø 18 cm /60° 26144 Standard ø 21 cm /50° 26141 Mini soft ø 44 cm silver 26166 Mini soft ø 44 cm white 26168 Snoot & Grid 26061 Grid for snoot 26427 Grids Grid set for reflector 18 cm 26135 Grid set for 21 cm 26051 Filters Set of 10 color/mixed filters for 21 cm x 21 cm 26243 Polarizing filter 21 cm 26244 Lightbanks ROTALUX Square 70 x70 cm 26178 Square 100 x100 cm 26179 Strip 95 x 35 cm 26 ...

www.elinchrom.com > Downloads > Product Registration i Please return this registratioin card directly to Diese Registrierkarte bitte direkt zurücksenden an Veuillez retourner cette carte d’enregistrement directement à Vi preghiamo di far pervenire questa cartolina di iscrizione direttamente a Por favor envie esta carta de registro directamente : : : : : elinca sa P.O. Box 458 Avenue de Lon ...