Whirlpool CAE2743BQ0 Installation Instructions Manual

2 Tools & Parts ............................................................. ...

of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety ale ...

LeveJ Pliers Utility Knife Adjustable Wrench Optional tools: Flat=Blade Screwdriver Parts Supplied: Water Inlet Hoses (2) O Inlet Hose Washers (4) Drain hose with clamp, U=form, and cable tie ...

on some models. T 35" (889 ram) ÷ 1" (25 ram) Side View 271/2" -,t----- (699 mm)_ I Non=coin=operated 27" "=---_ I models: (686 ram) _ 61/4,, ¢ ,--V (159 mm) ,' ' Coin-operated ..................... ...

performance and minimizes noise and possible washer "walk." Your washer can be installed in a basement, laundry room, or recessed area. See "Drain System." Companion appliance location requirements should also be considered. IMPORTANT." Do not install or store the washer where it wi ...

using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need. Floor standpipe drain system Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carry-away capacity: 10 gal. (38 L) per minute. Top of standpipe must be at least 39" (990 mm) high; install no higher than 96" (2.44 ...

Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. [] A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circ ...

Failure to do so can result in back or other injury. It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. 1. Move washer to within 4 ft (1.2 m) of its final location; it must be in a fully upright pos ...

due to water leakage. Remove drain hose from the washer drum 1. Remove tape from the washer drain port on the back of the washer. 2. If clamp is not already in place on elbow end of drain hose, slide it over end as shown. 3. Squeeze clamp with pliers and slide elbow end of drain ...

into each end of the inlet hoses. Firmly seat the washers in the couplings. Washer Coupling Connect inlet Hoses to Water Faucets 1. Attach hose to hot water faucet. Screw on coupling until it is seated on washer. Repeat process for cold water. ( Connect Inlet Hoses to Washer 1. Attach cold water hose to ...