Elmo Micro Video Camera System SUV-CAM Instruction Manual

should be read before the appliance is operated. „ Retain Instructions - The safety and operating instructions should be retained for future reference. „ Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. „ ...

THIS PRODUCT TO RAIN OR MOISTURE. The connection of a non- shielded equipment interface cable to this equipment will invalidate the FCC Certification or Declaration of this device and may cause interference levels which exceed the limits established by the FCC fo ...

Danger „ Do not disassemble or modify the battery pack. The battery pack is equipped with built-in safety protection features. Should these features be disabled, the battery pack can leak acid, overheat, emit smoke, burst and/or ignite. „ Do not connect the positive (+) and (-) terminals ...

leakage, overheating, smoke emission, bursting and/or ignition of the battery pack may occur. „ Do not directly solder the battery pack. Otherwise, heat can melt down its insulation, damage its gas release ...

leakage, overheating and/or smoke emission can occur. Also, its guaranteed performance will be lose and/or its service life will be shortened. „ The battery pack incorporates built-in safety d ...

Temperature of the main body When this recorder is used for a long time in the power-on state, the temperature of the main body may become high. However, this is not a fault. „ The power plug cord applicable to the local power specifications is attached. Be sure to use power cord applicable to your local power spec ...

„ When removing the battery, turn OFF the power supply to the recorder beforehand. „ When carrying the recorder or the camera head, be sure hold the recorder and the camera securely. „ When using the camera head or the recorder on your body, take care that the camera cab ...

and the higher or lower the humidity is, the more the battery is susceptible. * Whenever the use of this recorder ends, be sure to remove the battery. * Note: The shooting enabled time dur ...

Do not leave the SD memory card in any place that is exposed to high temperature or direct sunlight or any source of electromagnetic wares or static electricity. Also, do not bend, drop or strongly shock the SD memory card. Otherwise, the SD memory card could be broken or the contents of the SD memory card could ...