Elmo TND4204VX Instruction Manual

Text of the manual

VANDAL RESISTANT DOME CAMERA

INSTRUCTION MANUAL The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO U

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Clean only with dry cloth. 6. Do not block any ventilation openings, install in accordance with the manufacturer's instructions. 7. Do not install near heat sources such as radiators, heat registers, stoves or other app

Name and Function of Each part

1 2 3 4 5 6 No. Name Function The mounting bracket for ceiling installation. The main body of the camera section. For adjusting the image size. For adjusting the focus. Protective cover for the lens. Protective cover for the main body. Camera mounting bracket Main body Zoom ring Focus ring Cover lens Dome cover main body 6 5

Used when the white balance is in the PUSH mode.

For setting the vertical sync. phase. For adjusting the brightness of the image. For locking the tilt after adjusting the image up/down direction. Connect this to output images. When adjusting the image shooting direction, field angle or focus (in wiring work, for example

Selector switch (Details)

1.SENS UP switch To set the max. value (upper limit value) of the operating gain in the auto gain control circuit, set this switch to ON position. In case the back lighting is too dark and the camera sensitivity is insufficient, set this switch to ON position. 2. BLC (Back Light Control) switch In case the back lighting is too br

How to Install

1. Make holes in the mounting surface. (Fig. 1) The paper pattern for installation is included. 2. Remove the dome cover main body fixing screws from the camera body. (Fig. 2). Use the dedicated wrench (Attached). Be careful not to drop the cover dome. Camera mounting bracket Cover dome screw Dedicated wrench (Attached) Dome cover main body

3. Remove the main body fixing screws,

and remove the main body from the camera mounting bracket. (Fig. 3). Remove the screws identified by the mark(Figs. 4). 4. Fix the camera body to ceiling, wall or box with the camera body fixing screws. (Fig.5) Make sure that it

Camera mounting bracket

BNC cable Power cord Main body 7 5. Connect the power cord and the BNC cable, and then mount the main body on the camera body. (Fig. 6). · When you connect the Power cord and the BNC cable, roll the waterproof tape to prevent water damage as the figures below indicate. 6. While watching the monitor, adjust the i

Be careful not to drop the tilt lock

screw. Manually fasten the tilt lock screw. If fastened with pliers or the like, the tilt lock screw may be broken. 7. Correct the image tilt. (Fig.9) Be sure to hold the cover motor. 8. Mount the cover lens, and mount the dome cover with the dome cover fixing screws. (Fig.10) Camera mounting bracket Lens Tilt lock scr

All dimensions in mm(inch)

When any failure is suspected Symptoms Image is not displayed. Color is not correct. Image is disarrayed. Check here. Are cables connected correctly? Are the power plugs of peripheral units inserted correctly into the receptacles? Is the video monitor adjusted correctly? Is any connector of this m

Other Security Camera Manuals