Windster WS-5830SS Operation & User’s Manual

using your range hood. Store it in a safe location for when you need to reference it in the future. NOTE: PLEASE INSPECT HOOD IMMEDIATELY UPON RECEIVING. CLAIM OF DAMAGE AFTER 7 DAYS OF DELIVERY WILL BE DENIED. This unit is designed for indoor ...

Safety Information .............................................................. 2 – 3 Content Checklist ..................................................................... 4 Measurements ........................................................................... 5 Preparation ....................................................... ...

AND/OR INJURY OBSERVE THE FOLLOWING: Unit is intended for indoor residential use only. If you should have questions, contact the manufacturer at the address or telephone number listed in the warranty. In case the unit should need to be cleaned or repaired, switch power off at service panel a ...

USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE. Regardless of heat level, never leave any surface materials unattended while operating an open flame. Always turn hood ON when cooking at high heat or when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé). Depending on ...

a. (1) WS58 series(30”, 36” or 42”)hood assembly b. (1) User’s manual c. (1) Black 6” to 7” conversion collar d. (2) Aluminum filters(30” model only) e. (3) Aluminum filters (36” and 42” model only) f. (1) Screw packet 2. CONTENTS NOT INCLUDED a. WS58CFMR (CFM reducer) b. WS58DK (30”, 36” or 42”) ...

**DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have all the content of your purchase and required tools for this installation. b. Installation may take at least 1 to 2 hours from start to finish. c. Plan to use as few elbows or turns as possible for more efficient air flow. d. C ...

both sides to balance the recession. Use (4) 1-1/4” long flat head screws to secure the wood strips to cabinet.(Fig. 1d) 3. HOOD a. Inspect for any sign of defect or damage. (ie. scratches, dents, loose seams, etc.) b. Power up the unit to make sure it is working properly. c. ...

a. Make sure all preparation steps are completed. b. Feed the wires coming out of the hood through the bottom of the cabinet. c. Lift the unit up flush against the wall and the bottom of the cabinet. d. Using the screws and washers provided, insert into each of the keyhole openings and tightly secure the unit agains ...

a. Make sure all preparation steps are completed. b. Lift the ductless kit up flush against the wall and the bottom of the cabinet. (Fig. 2a) c. Using the screws and washers provided, insert into each of the keyhole openings and tightly secure the ductless kit against the bottom of the cabinet.(Fig. 2b) d. Lift the unit up ...