Teac AG-790 Owner's Manual
Text of Teac AG-790 Owner's Manual
AM/FM Stereo Receiver
OWNER’S MANUAL
MANUEL DU PROPRIÉTAIRE
MANUAL DEL USUARIO
BEDIENUNGSANLEITUNG
MANUALE DI ISTRUZIONI
GEBRUIKSAANWIJZING
Z
AG-790
FRANÇAIS
ESPAÑOL
DEUTSCH
ITALIANO
NEDERLANDS
Thank you for choosing TEAC. Read this manual carefully
to get the best performance from this unit.
Before Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Remote Control Unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Connecting Antennas . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Connection. . . . . . . . . . . . . . . . . . . . . . . . . . .
FM Indoor Antenna
Connect the lead-type FM antenna to the FM 75Ωsocket,
extend the lead and tune the tuner to your favorite station
(see page 13). Adjust the antenna in a suitable location like a
window frame or wall until the reception is best and then
affix the antenna in that position using thumb tacks, push
pins or any other suitable means.
FM Outdoor Antenna
In an area where FM signals are weak, it will be necessary to
use an o
AM Indoor Loop Antenna
The high-performance AM loop antenna provided with this
unit is sufficient for good reception in most areas.
To stand the loop antenna on a surface, fix the claw to the
slot in the antenna base.
Connect the loop antenna’s wires to the AM antenna
terminals.
How to connect:
Press the lever, insert the end of the cord,
then release the lever. Make sure it is
fastened securely by pulling the cord lightly.
Make sure only the b
< Switch off the power to all equipment before making connections.
< Read the instructions of each component you intend to use with this unit.
< Be sure to insert each plug securely. To prevent hum and noise, avoid bundling the signal
interconnection cables together with the AC power cord or speaker cables.
CD PLAYER
TURNTABLE
TAPE
Speakers A
Speakers B
CD, TAPE MONITOR, VIDEO/AUX jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect the component with commercially-available
RCA cables.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
PHONO jacks/SIGNAL GND terminal
Connect the turntable’s RCA pin cords to PHONO jacks.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right ch