Teledyne 3010TA Operating Instructions Manual

Text of Teledyne 3010TA Operating Instructions Manual

Trace Oxygen Analyzer

Flush Mount Control Unit, PN D-64596A* NEC Type Analysis Unit, PN D-65478* HIGHLY TOXIC AND OR FLAMMABLE LIQUIDS OR GASES MAY BE PRESENT IN THIS MONITORING SYSTEM. PERSONAL PROTECTIVE EQUIPMENT MAY BE REQUIRED WHEN SERVICING THIS SYSTEM. HAZARDOUS VOLTAGES EXIST ON CERTAIN COMPONENTS INTERNALLY WHICH MAY PER- S

Copyright © 1999 Teledyne Analytical Instruments

All Rights Reserved. No part of this manual may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any other language or computer language in whole or in part, in any form or by any means, whether it be electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written consent o

Table of Contents

Specific Model Information.................................. iv Preface ................................................................v Part I: Control Unit, Model TA................. Part I: 1-1 Part II: Analysis Unit, Model T ............... Part II: 1-1 Appendix ......................................................... A-1

Specific Model Information

The instrument for which this manual was supplied may incorporate one or more options not supplied in the standard instrument. Commonly available options are listed below, with check boxes. Any that are incorpo- rated in the instrument for which this manual was supplied are indicated by a check mark in the box. Instrument Serial Number: __________________________

The Analytical Instruments Model 3010TA Trace Oxygen Analyzer is a

versatile microprocessor-based instrument for detecting parts-per-million (ppm) levels of oxygen in a variety of background gases. It is a “split archi- tecture” instrument. This means that a general purpose Control Unit, de- signed for nonhazardous areas only, remotely controls a spe

on your Instruments to be sure of a match. Where an underscore (_) appears

in a model number, the unit has more than one application. For example, 3010T_C means that the same unit is part of the 3010TAC and the 3010TBC models. 3010TA: NEC Type Trace Oxygen Analyzer with flush mount Control Unit. Consists of 3010TA Control Unit, PN D-64596A and a 3010T Analysis Unit, PN D-65478. 3010PA: NEC

Stainless steel cell block is standard equipment.

• Advance design Micro-Fuel Cell sensor, Specially designed model for trace analysis, has a one year warranty and an expected lifetime of two years. • Versatile analysis over a wide range of applications. • Microprocessor based electronics: 8-bit CMOS microprocessor with 32 kB RAM and 128 kB ROM. • Three use

Part I: i

Part I: Control Unit OPERATING INSTRUCTIONS Model 3010TA Oxygen Analyzer Part I: Control Unit Flush Mount Part Numbers: D-64596A

ii: Part I

Model 3010TA Oxygen Analyzer Table of Contents 1 Introduction 1.1 Overview ........................................................................ 1-1 1.2 Control Unit Front Panel................................................. 1-1 1.3 Recognizing Difference Between LCD & VFD............... 1-3 1.4 Control Unit Rear Panel ................................................. 1-3 2 Operational Theory 2.1 Introduction ..............................

Teledyne Analytical Instruments Owners Instructions: