EVGA P55 Micro V Operation & User’s Manual

Text of the manual

Table of Contents

Congratulations! ................................................................................................ 2 Parts NOT in the Kit ........................................................................................... 2 Hardware Installation .......................................................................................

Thank you for purchasing this EVGA P55 Chipset based motherboard.

This motherboard from EVGA offers high performance, quality features and superior support. If you have any questions about this product please visit www.evga.com to read the EVGA FAQ, visit our forums or contact us directly. Parts NOT in the Kit This kit contains all the har

Preparing the Motherboard

Installing the CPU Be very careful when handling the CPU. Hold the processor only by the edges and do not touch the contacts on the motherboard or CPU. Any physical damage to the motherbard pins will void the warranty. Use the following procedure to install the CPU onto the motherboard: 1. Unhook the socket lever by pushing down a

Installing System Memory (DIMMs)

Your new motherboard has four 240-pin slots for DDR3 memory. These slots support 512 MB, 1GB, 2GB, and 4GB DDR3 technologies. There must be at least one memory bank populated to ensure normal operation. Use the following the recommendations for installing memory.  One DIMM: If using 1 DIMM (Single Channel), install into:

Securing the Motherboard into a System Case

Most system cases have a base with mounting studs or spacers to allow the motherboard to be secured to the chassis and help to prevent short circuits. If there are studs that do not align with a mounting hole on the motherboard, it is recommended that you remove that stud to prevent the possibility of a short cir

24-pin ATX Power (ATXPOWER)

ATXPOWER is the main power supply connector located along the edge of the board next to the DIMM slots. Make sure that the power supply cable and pins are properly aligned with the connector on the motherboard. Firmly plug the power supply cable into the connector and make sure it is secure. Connector Pin Signal Pin Signal 1 +3.

Front Panel Header (F_PANEL)

The front panel header on this motherboard is one connector used to connect the following four cables.  PLED Attach the front panel power LED cable to these two pins of the connector. The Power LED indicates the system’s status. When the system is turned on, the LED is on. When the system is turned off, the LED is off.

Enter BIOS Setup

The BIOS is the communication bridge between hardware and software. Correctly setting the BIOS parameters is critical to maintain optimal system performance and stability. Use the following procedure to verify/change BIOS settings. 1. Power on the computer. 2. Press the Del key when the following message briefly displays at the bottom of t

Other Motherboard Manuals