Extron electronics DVI DA Plus Series Operation & User’s Manual
Text of Extron electronics DVI DA Plus Series Operation & User’s Manual
This symbol is intended to alert the user of important operating and maintenance
(servicing) instructions in the literature provided with the equipment.
This symbol is intended to alert the user of the presence of uninsulated dangerous
voltage within the product enclosure that may present a risk of electric shock.
Caution
Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Retain Instructions • The
FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
The Class A limits are designed to provide reasonable protection against harmful interfe
Introduction ............................................ 1
About this Guide ........................................... 1
About the DVI DA Plus Series ....................... 1
Features ......................................................... 2
Installation .............................................. 3
Installation Overview .................................... 3
Rear Panel Features....................................... 4
DVI Connector Pin As
About this Guide
This user guide describes the installation, operation, and specifications of the Extron®
DVI DA4 Plus, DVI DA6 Plus, and DVI DA8 Plus Distribution Amplifiers.
Unless stated otherwise, all references to the “distribution amplifier,” “DA,” or “DVI DA Plus
Series” in this guide refer to the features or operation of all three models.
About the DVI DA Plus Series
These Digital Visual Interface (DVI) Distribution Amplif
EDID Minder — The EDID Minder maintains continuous EDID (Extended Display
Identification Data) communication with the attached source to ensure that the DVI source
powers up correctly and maintains a proper video output, even if the display is off.
EDID Lock — The last recorded EDID is saved to the input and used after a power cycle or
after displays have been changed. The EDID presented to the input is not affected by power
cycles or changing
This section describes:
•
Installation Overview
•
Rear Panel Features
Installation Overview
All three distribution amplifiers can be mounted on tabletops, under furniture, and in racks
by following these steps:
1. Ensure that the input sources, the distribution amplifier and the output displays are all
turned off and all power sources and signal cables are disconnected.
2. Mount the unit as described in “Mounting” on page 15.
3. Connec