Fantom FM742CS Instruction Manual

Text of Fantom FM742CS Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

NAME OF EACH PART PREPARATION BEFORE USE USING THE VACUUM CLEANER USING THE ATTACHMENTS EMPTYING THE DUST COMPARTMENT CLEANING THE FILTERS CLEARING BLOCKAGES IN THE SUCTION HOSE AND CLEANING THE AGITATOR ASSEMBLY REPLACEMENT INSTRUCTIONS TROUBLESHOOTING LIMITED WARRANTY Contents 1 3 4 6 8 9 10 11 12 16 16 17 FM742CS INSTRUCTION MANUAL VACUUM CLEANER FOR HOUSEHOLD OR COMMERCIAL USE

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - To reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use and before servicing. 2. Do not use outd

Do not touch the agitator while it is spinning.

17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth which looks as though they may cause the hose to become blocked. 20. Do not clean or store the vacuum cleaner in places where there are high temperatures. 21. Store the vacuum cleaner away from excessive humidity. 22. When carry

Set the ON/OFF switch

to " ON " to light the headlight. 3 NAMES OF EACH PART WARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Cleaning Utensil Headlight Handle Suction Hose A Dust Compartment Carrying Handle Duster Knob ON/OFF Switch Release Button A Release Button B Release Button C Suction Hose B Filter Cover Wand Handle Release Lever Power Cord Upholstery Tool & Dusting Brush Power Cord Plug Crevice Tool Hose Hold

& Dusting Brush

Hose Cuff Suction Inlet Suction Hose A Caution: Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle PREPARATIONS BEFORE USE Attaching the suction hose A & attachments 4 1 2 Set the vacuum cleaner to the upright position. lnsert the handle as shown in the illustration. Handle

PREPARATIONS BEFORE USE

WINDING THE POWER CORD Hook the power cord over the clip which is located on the upper cord storage hook as shown. 2 Wind the power cord around the cord storage hooks. INSERTING THE POWER CORD PLUG Plug Side Clip Secure the power cord plug on the power cord. Cord Storage Hooks THERMAL SAFETY DEVICE IN MAIN BODY To protect your vacuum cleaner motor from overheating, a thermal safety device has been built in. If your vacuum cl

This position is used for cleaning under

furniture. Handle Release Lever Handle Release Lever ON/OFF Switch 6 USING THE VACUUM CLEANER ON/OFF SWITCH Start or stop vacuum cleaner by pushing on the switch. ADJUSTING THE HANDLE Upright position The handle is normally locked in this The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel. Place your foot on handle release lever as shown and pull back

Fantom Vacuum Cleaner Owners Instructions: